Canon Satera MF6880dw
Adjustment. After Replacing. Main Controller PCB
Actions before Replacement
Perform backup of user data (such as Settings/Registration data) and service mode data to set/register them again after replacing the PCB. Write down the data which cannot be backed up.
- Export user data using remote UI.
- Insert the USB memory into the host machine, and execute COPIER > FUNCTION > SYSTEM > EXPORT to write the setting values of the service mode (excluding those related to the Reader/DADF) to the USB memory.
- Write down the serial number of the host machine and each factory adjustment value written on the service label. (Enter them after replacement.)
Actions after Replacement
- Error code "E248-0001" lights up when turning ON the power.
- Execute COPIER > FUNCTION > CLEAR > R-CON.
- Enter all items written on the service label.
- Set the location group and paper size group.
• COPIER > OPTION > BODY > LOCALE (setting the location group)
[Setting value]
1: Japan, 2: North America, 3: Korea, 4: China, 5: Taiwan, 6: Europe, 7: Asia, 8:
Oceania
• COPIER > OPTION > BODY > SIZE-LC (setting the paper size group)
[Setting value]
1: AB configuration, 2: Inch configuration, 3: A configuration, 4: AB/Inch configuration - Clearing the Settings/Registration data
Execute COPIER > FUNCTION > CLEAR > ALL.
When executing this item, the following data is cleared according to the values of LOCALE and SIZE-LC set in step 4.
• Settings/Registration data (the initial value according to the location is set.)
• Service mode data (the initial value according to the location is set.)
• Job ID
• Each log data
• Date data
Note that the following data is not cleared.
• Service counter
• Adjustment value of Reader/DADF - Execute COPIER > FUNCTION > VIFFNC > STOR-DCN (the setting value of DC Controller is backed up.)
- Turn OFF and then ON the power.
- Operate according to the instruction on the screen since the initial installation mode is activated. (Setting the date/time, executing the auto gradation adjustment)
- Enter the serial number (8-digit alphanumeric) in Settings/Registration > System Settings > Device Information > Location.
- After selecting COPIER > OPTION > SERIAL > SN-MAIN, press OK key to write the serial number entered in step 4 in the Main Controller PCB. After writing, the serial number entered in "Location" in step 9 is deleted.
- Turn OFF and then ON the main power.
- Execute COPIER > FUNCTION > MISC-P > SPEC to output the spec report to check the serial number (Body.No.).
- Enter the data backed up earlier in Settings/Registration > System Settings > Device Information > Location.
- Import the service mode data backed up before replacement. Insert the USB memory storage device to the slot of the machine, and execute COPIER > FUNCTION > SYSTEM > IMPORT.
- Import user data using remote UI.
- Uninstall the drivers on the user's PC.
• Printer driver
• Fax driverr
• Scanner driver
• Network Scan Utility (in case of network connection)
* For the procedure, refer to "When Deleting the Installed Software" in the Startup Guide. - Install the drivers again which were uninstalled in step 16.
* For the procedure, refer to the following items in the Startup Guide.
In case of network connection: "Installing the Network Connection"
In case of USB connection: "Installing the USB Connection