Canon MF7450N
Service Mode. 01 Outline
Service Mode contains the following service data items. Each service data can be viewed or modified using the menu items displayed on the screen.
#SSSW
Use it to register/set basic fax functions (e.g., error control, echo remedy, communication error correction). Use it to make settings related counter functions.
#MENU
Use it to register/set items related to functions needed at time of installation (e.g., NL equalizer, transmission level).
#NUMERIC PARAMETER
These setting items are for inputting numeric parameters such as the various conditions for the RTN signal transmission.
#SPECIAL
These setting items are for telephone network control functions
#NCU
These setting items are for telephone network control functions such as the selection signal transmission conditions and the detection conditions, for the control signals sent from the exchange.
#SCAN
These setting items are for image adjustment in scanning.
These setting items are for image adjustment in printer assembly and for special mode for the field-related measures.
#NETWORK
Use it to confirm the contents of the installed CA certificates.
#SYSTEM
These are used for the import/export of user information through USB.
#ACC
Register the accessories.
#COUNTER
Use it to check estimates for maintenance/parts replacement.
#LMS
Use it to set the inactivity of the transmitted license and the license inactivity without transmitting.
#E-RDS
This is a setting items related to e-RDS (Embedded RDS).
#REPORT
Use it to generate reports on various service data.
#DOWNLOAD
Use it to download firmware to the ROM of a PCB in question.
#CLEAR
Use it to reset various data to initial settings.
#ERROR DISPLAY
An error code is displayed when a service error has occurred.
#ROM
Displays ROM information, such as version numbers and checksums.
#TEST MODE
Makes various status checks, such as contact sensor, sensor and print status.