Brother MFC-L8600CDW
Troubleshooting. 2.9. Paper jam at the paper tray 1
User Check
- Check if the paper is loaded into the paper tray 1 correctly.
- Turn back the paper loaded in the paper tray 1 or change the orientation of the paper by 180°.
- Adjust the paper guide corresponding to the paper size.
- Check if too much paper is loaded in the tray.
- Check if the thickness of the paper is 60 to 105 g/m2.
- Fan the stack of paper well and reinsert the papers into the paper tray.
- Replace the toner cartridge with a new one.
- Replace the drum unit with a new one.
Step | Cause | Remedy |
---|---|---|
1 | Foreign object around paper tray 1 | Remove the foreign object. |
2 | T1 paper dust cleaning roller installation failure | Re-assemble the T1 paper dust cleaning roller. |
3 | Registration front actuator coming off | Re-assemble the registration front actuator. |
4 | Connection failure of the registration front/rear sensor PCB harness | Reconnect the registration front/rear sensor PCB harness. |
5 | Registration front sensor failure | Replace the registration front/rear sensor PCB ASSY. |
6 | Fuser drive gear Z25 damaged | Replace the fuser drive gear Z25. |
7 | Main motor failure | Replace the process drive unit. |
8 | Paper feed related gear damaged | Replace the main drive unit. |
9 | Paper feed unit failure | Replace the paper feed unit. |
10 | Fuser unit damaged | Replace the fuser unit. |
11 | Main PCB failure | Replace the main PCB ASSY. |