Brother MFC-L8600CDW
Troubleshooting. 2.2. No paper feeding from T2 paper tray unit
User Check
- Check if the paper is loaded into the paper tray correctly.
- Check that too much paper is not loaded in the paper tray.
- Turn back the paper loaded in the paper tray or change the orientation of the paper by 180°.
- Check if the thickness of the paper is 60 to 105 g/m2.
- Check whether the MP tray or paper tray 1 is specified for the paper feeding tray.
- Fan the stack of paper well and reinsert the papers into the paper tray.
- Clean the T2 paper pick-up roller.
- Check whether the paper tray 1 is closed correctly.
Step | Cause | Remedy |
---|---|---|
1 | T2 paper feed actuator coming off | Re-assemble the T2 paper feed actuator. |
2 | Connection failure of the main motor harness | Reconnect the main motor harness. |
3 | T2 roller holder ASSY installation failure | Install the T2 roller holder ASSY correctly. |
4 | Connection failure of the T2 paper feed/plate origin sensor PCB harness | Reconnect the T2 paper feed/plate origin sensor PCB harness. |
5 | Connection failure of the T2 registration sensor PCB harness | Reconnect the T2 registration sensor PCB harness. |
6 | Connection failure of the T2 relay PCB harness | Reconnect the T2 relay PCB harness. |
7 | T2 paper pick-up roller worn out | Replace the PF kit 2. |
8 | T2 relay PCB failure | Replace the T2 relay PCB ASSY. |
9 | Main motor failure | Replace the process drive unit. |
10 | Paper feed related gear damaged | Replace the main drive unit. |
11 | Fuser unit damaged | Replace the fuser unit. |
12 | Main PCB failure | Replace the main PCB ASSY. |
13 | T2 connector or T2 plate motor failure | Replace the T2 paper tray unit. |