Brother HL3160CDW

2.5 Paper is fed at an angle

User Check

• Check that the paper is set in the T1 correctly.
• Flip over the paper in the T1 or rotate the paper 180°.
• Adjust each paper guide according to each paper size.
• Check that the thickness of the paper is 60 to 163 g/m2.
• Check that there is not too much paper set in the T1.
• Check that the type of paper is appropriate.
• Clean each paper pick up roller.
• Check that the green envelope lever of the fuser cover is not lowered on only one side.

Step	Cause	Cause
1	One-side abrasion of the paper pick up rollers	Replace the appropriate PF kit 1.
2	Paper feed unit failure	Replace the paper feed unit.

2.6 Paper curls

User Check

• Change the driver setting to be matched with the size of the paper set in the T1.
• Select “Reduce Paper Curl” in the driver.
• Check that the paper is set in the T1 correctly.
• Open the back cover and try printing with straight paper ejection mode.

Step	Cause	Cause
1	Fuser unit failure	Replace the fuser unit.
2	Main PCB failure	Replace the main PCB.