Brother HL-L2366DW
Troubleshooting. 2.2 No paper is fed from manual feed slot, Multiple sheets of paper are fed
2.2 No paper is fed from manual feed slot
User Check
• Check that the paper is set into the deepest part of the manual feed slot.
• Check that multiple sheets of paper are not set in the manual feed slot.
• Check that the thickness of the paper is 60 to 163g/m2.
• Check that the paper tray is not set as the pick
Step | Cause | Remedy |
---|---|---|
1 | Connection failure of the main motor flat cable | Reconnect the main motor flat cable. |
2 | Connection failure of the registration clutch harness | Reconnect the registration clutch harness. |
3 | Registration front actuator coming off | Reattach the registration front actuator. |
4 | Connection failure of the registration front sensor PCB harness | Reconnect the registration front sensor PCB harness. |
5 | Connection failure of the HVPS flat cable | Reconnect the HVPS flat cable. |
6 | Registration clutch failure | Replace the registration clutch. |
7 | Registration front sensor failure | Replace the registration front/rear actuator holder ASSY. |
8 | HVPS flat cable breakage | Replace the HVPS flat cable. |
9 | Main motor failure | Replace the main motor. |
10 | Damaged fuser unit | Replace the fuser unit. |
11 | High-voltage power supply PCB failure | Replace the high-voltage power supply PCB ASSY. |
12 | Main PCB failure | Replace the main PCB ASSY. |
2.3 Multiple sheets of paper are fed
User Check
• Check that there is not too much paper set in the paper tray.
• Check that the paper is set in the paper tray correctly.
• Flip over the paper in the paper tray or rotate the paper 180°.
• Check that the thickness of the paper is 60 to 105g/m2.
• Flip through the paper and reset it in the paper tray.
Step | Cause | Remedy |
---|---|---|
1 | Abrasion of the separation pad | Replace the PF kit. |