Brother HL-L2305W
Troubleshooting. 2.8.3 Paper jams in the feeding path in the center of the machine
User Check
• Check that the paper is set in each paper tray correctly.
• Flip over the paper in each paper tray or rotate the paper 180°.
• Adjust each paper guide according to the paper size.
• Check that there is not too much paper set in the paper tray.
• Check that the thickness of the paper is 60 to 105g/m2. (60 to 163g/m2 for manual feed slot)
• Flip through the paper and reset it in the paper tray.
• Replace the drum unit.
Step | Cause | Remedy |
---|---|---|
1 | Foreign object inside the machine | Remove the foreign object. |
2 | Eject actuator coming off | Reattach the eject actuator. |
3 | Connection failure of the eject sensor PCB flat cable | Reconnect the eject sensor PCB flat cable. |
4 | Connection failure of the registration clutch harness | Reconnect the registration clutch harness. |
5 | Fuser cover attachment failure | Reattach the fuser cover. |
6 | Registration clutch failure | Replace the registration clutch. |
7 | Eject sensor failure | Replace the eject sensor PCB ASSY. |
8 | Registration rear sensor failure | Replace the registration front/rear actuator holder ASSY. |
9 | Main motor failure | Replace the main motor. |
10 | High-voltage power supply PCB failure | Replace the high-voltage power supply PCB ASSY. |
11 | Damaged gears in the feeding system | Replace the main frame L ASSY. |
12 | Fuser unit failure | Replace the fuser unit. |
13 | Main PCB failure | Replace the main PCB ASSY. |