Brother DCP1600
Maintenance Mode. List of Functions
Function code | Function |
---|---|
01 | Initialize EEPROM parameters |
05 | Print white level / black level data for document scanning compensation |
06 | Move CIS unit to transportation position |
08 | ADF performance test |
09 | Monochrome image quality test pattern |
10 | Set worker switches (WSW) |
11 | Print worker switch (WSW) setting data |
12 | Check LCD operation |
13 | Check control panel button operation |
25 | Display software version |
32 | Check sensor operation |
33 | Display LAN connection status |
43 | Set PC print functions |
45 | Change USB No. return value |
52 | Set country / language |
53 | Transfer received fax data / log information |
54 | Fine-tune scanning position |
55 | Acquire white level data and set CIS scan area |
67 | Print test |
69 | Print frame pattern (single-side printing) |
71 | Print test pattern |
74 | Setting by country |
77 | Print maintenance information |
78 | Operational check of fans |
80 | Display machine log information |
82 | Display machine error code |
87 | Send communication log information to telephone line |
88 | Reset irregular power supply detection counter of low- voltage power supply PCB |
91 | Initialize EEPROM parameters |
99 | Quit maintenance mode |
The maintenance mode functions shaded in the table can be used by end users.
Initialize EEPROM parameters (Function code 01, 91)
This function is used to initialize the setting values for operation parameters, user switches, and worker switches (WSW) registered in the EEPROM. Entering function code 01 initializes most EEPROM areas. Entering function code 91 initializes only the specified areas as shown in the table below.
Operating Procedure
- Press the [0], and then the [1] (or press the [9], and then the [1] as required) in the initial state of maintenance mode. For models without keypad, press the [▲] or [▼] to display “MAINTENANCE 01” (or “MAINTENANCE 91” as needed) on the LCD and press the [OK]. “PARAMETER INIT” is displayed on the LCD.
- When initializing parameters is completed, the machine returns to the initial state of maintenance mode.
Note: Function code 01 is for service personnel. Function code 91 is for user support.