Brother DCP-J572DW
Maintenance Mode. 02. Error code
Creating of Head Calibration Data and Writing it into Flash ROM (Maintenance mode 02)
Error code | The following error has occurred. | Do the following: |
---|---|---|
01 | Failed to detect the external frame. | - Clean the document cover glass. - Reset the print pattern so that the ▲ mark is aligned with the left rear of the document cover without tilt. - Check that there is no block missing. - Go back to step (2) and print out "Print pattern for creating head calibration data" again. |
02 | Internal image inclined. | |
03 | Failed to detect position. | |
04 | Failed to write head calibration data. | - Clean the document cover glass. - Reset the print pattern so that the ▲ mark is aligned with the left rear of the document cover without tilt. - Check that there is no block missing. - Restart the machine and perform the procedure from the beginning again. - Replace the main PCB. |
05 | The uneven printing correction function for upper and lower ends of the nozzle is disabled with Maintenance 88. | - Set selector 1 on AMS05 to "0" (ON) in “Assurance Mode Switch Setting (Maintenance mode 88)” in this chapter. |
06 | Cannot get data due to memory full. | - Delete fax data and other data stored in the memory. - Replace the main PCB. |
07 | The document scanner unit is open. | - Close the document scanner unit. - Reconnect the document scanner sensor harness. - Replace the document scanner if the boss that presses the document scanner sensor is broken. - Replace the main PCB. |
09 | Scanning errors other than the above. | - Use “Acquisition of White/Black Level Data (Maintenance mode 55)” in this chapter. |
10 | With a media being inserted, the USB cable or LAN cable is connected. | - Disconnect the USB cable or LAN cable. |