Description: 1. At Warm-up, Duplex Ready sensor has detected the paper. 2. At Printing, Duplex sensor is not off within a programmed period of time after paper moves into duplex path.
Causes: 1. Check the Duplex Ready Sensor Harness and Connector. 2. Check if the UI message is changed by the Duplex Ready Sensor operation. 3. Check the duplex ready sensor
Remedy: 1. Open the Front Cover and separate the PTB unit. Remove the Jammed paper. 2. If the paper is not reached to the duplex path after the exit sensor sensing, check the Clutch-BK deve. If it is defective, replace it. 3. Check if exit actuator’s replace time is not accuracy. If so, check if the spring of exit actuator exists or not. 4. Check if exit motor reverses when the paper needs to reload to the printer.
Code: 01-017
Display: Output bin Full. Remove paper
Description: The out-bin full sensor is on for 600ms.
Causes: 1. Check the Out-Bin Full Sensor Harness and Connector. 2. Check if the UI message is changed by the Out-Bin Full Sensor operation. 3. Check the Out-Bin Full Sensor.
Remedy: 1. Clear the paper on exit tray. 2. Reconnect the CN3 connector on Main-PBA. 3. Replace the Actuator-Stacker and Actuator-OutFull. * Actuator-Stacker (JC66-02065A) * Actuator-Outfull (JC66-02064A) * Photo-Interrupter (0604-001095)
Code: 02-000
Display: Error :#02-000 Please turn off then on.
Description: At Warm-up, this error has occurred. The machine does not work until power off/on.
Causes: Fuser Unit is not installed and AC is not supplied to the Heat Lamp.
Remedy: 1. Turn off the power. And turn on the power. 2. If the problem persists, replace the fuser unit. 3. If the problem persists after replacing the fuser unit, reconnect the CN35 connector on Main-PBA. 4. If the problem persists, replace the Main-PBA.
Code: 02-001, 02-006
Display: Error :#02-001 Please turn off then on.
Description: At Warm-up, this error has occurred. The machine does not work until power off/on.
Causes: Fuser Unit is not installed and AC is not supplied to the Heat Lamp.
Remedy: 1. Turn off the power. And turn on the power. 2. Check the connection of the Fuser AC on FDB ‡A. 3. Check the Fuser control harness ‡@. 4. Remove the resistance value of the thermostat. If the value is infinite, replace the thermostat. 5. If the problem persists, replace the Fuser unit. 6. Replace the SMPS board or FDB (Fuser drive board).
Code: 02-002
Display: System Error :#02-002 Please turn off then on.
Description: The fuser unit is overheated. The machine does not work until power off/on.
Causes: The machine can not control fuser temperature.
Remedy: 1. Turn off the power. And turn on the power. 2. Replace the Fuser unit. 3. Replace the FDB. 4. Replace the Main-PBA.
Code: 02-005
Display: System Error :#02-005 Please turn off then on.
Description: The ADC port is short.
Causes: The machine can not control fuser temperature.
Remedy: 1. Turn the power off then on again. 2. If the problem persists, replace the Main PBA.