Causes: 409 The paper-ejection sensor was OFF when the paper should have arrived, and the paper sensor was ON at 180°, just before stopping. 412 The paper sensor was OFF three times in succession when a paper misfeed was detected (paper misfeed). 418 The paper sensor was ON at the start of operation.
Remedy: Turn the paper sensor OFF and reset the jam (or switch the power on again).
Code: A08
Description: Paper jam on print drum
Causes: 410 The paper-ejection sensor was OFF when paper should have arrived, and the paper sensor was OFF at 180° just before stopping. 421 The paper sensor was ON when the paper should have left the paper sensor during feeding of long paper in long-length paper mode (paper longer than 555 mm). Error command (Main unit: Jam error) received from the multi-tray unit After paper-sensor turns ON, and multi-tray transfer motor rotates a certain amount of pulses, the paper-sensor did not turn OFF. (Multi-tray feed sensor 1 to 3: OFF and 4: ON and paper sensor: ON) or (Multi-tray feed sensor 4: ON and paper sensor: ON at
Remedy: Print-drum set sensor: OFF -> ON (Or switch the power on again.)
Code: A09
Description: Paper-ejection error
Causes: 411 The paper-ejection sensor was ON when the paper should have left the paper-ejection sensor. 417 The paper-ejection sensor was ON at the start of operation.
Remedy: Turn the paper-ejection sensor OFF and reset the jam, or switch the power on again.
Code: A10
Description: ADF original feed error
Causes: 102 Original-registration-sensor remaining jam 103 Original-IN-sensor remaining jam 104 Original-OUT-sensor remaining jam 105 Original-registration-sensor non-arrival jam 106 Original-IN-sensor non-arrival jam 107 Original-OUT-sensor non-arrival jam 109 An original feed error occurred, due to opening the ADF. 162 No original in ADF during ADF master making.
Remedy: Turn the ADF original detection sensor OFF, and reset the jam.
Code: A16
Description: Awaiting master removal
Causes: 525 Awaiting master removal
Remedy: Print-drum set sensor: OFF -> ON
Code: A17
Description: Cutter error
Causes: 209 The cutter home-position switch was OFF during master setting at the start of master making.
Remedy: Master-loading set unit: OFF -> ON; master-detection sensor: OFF