Remedy: Master disposal boxl set sensor OFF & 5 seconds later ON. • Empty the disposal box.
Code: C8
Description: Replace Ink bottle
Causes: • If the Ink sensor does not detect ink in the Squeegee unit within 20 seconds after the Inking motor was activated. • If the Ink sensor does not detect ink in the Squeegee unit within 40 seconds after the Inking motor was activated when the Ink bottle is installed just after replacing empty ink bottle.
Remedy: Ink bottle set sensor OFF & 5 seconds later ON.
Code: E1
Description: Main Motor Lock
Causes: • If excessive current is detected 0.3 seconds consecutively after the Main motor is activated. • If no Encoder sensor output after Main motor is activated.
Remedy: Turn Power SW OFF & ON.
Code: E12
Description: Master removal motor lock
Causes: • Excessive current to the motor is detected three time consecutively during the current check made every 100 ms.
Remedy: Turn Power SW OFF & ON.
Code: E13
Description: Cutter motor Lock
Causes: • If the Cutter home position switch is not turned OFF within 500 ms after the Cutter motor is activated. • If the Cutter end position switch is not pressed within 2000 ms after the Cutter motor is activated.
Remedy: Use test mode.
Code: E16
Description: Inking Motor Lock
Causes: • If excessive current is detected 2.5 seconds consecutively after the Inking motor is activated.