Causes: 411 Paper-ejection sensor was ON when the paper should have left the paper-ejection sensor. 417 Paper-ejection sensor was ON at the start of machine operation when the START button was pressed.
Code: A10
Display: A10 [AF original feed error]
Description: A10 [AF original feed error]
Causes: 102 The original is pulled out from the AF unit before the scanning is completed. 103 Original jammed under Original IN sensor. 107 Original does not arrive to the Original IN sensor.
Code: A16
Display: A16-xxx Master Remains on Print Cylinder (Drum) Pull Out Print Cylinder and Remove Master
Description: A16 [Waiting for the master to be removed from the drum]
Causes: 525 Waiting for the master to be removed from the print cylinder (drum).
Code: A17
Display: A17-xxx System Error in Master Making Unit Take Out Master and then Close Master Making Unit Cover
Description: A17 [Cutter error]
Causes: 209 Cutter HP switch is OFF when master-making starts, when the master material is set in the master making unit, or when the machine goes into idle condition. 213 Master material is not set in position when the machine goes into idle condition.
Code: A34
Display: A34-xxx Master Not Set in Place Insert Lead Edge of Master into Master Entrance and Close Master Making Unit
Description: A34 [Requesting for the master to be reset]
Causes: 218 Reqesting for the leading edge of the master material to be set in the master making unit.
Code: B22
Display: B22-xxx !! Job Separator is OFF !! Turn On Power Switch of it
Description: B22 [Job separator: Power off]
Causes: 721 With the [Tape separation] function set ON, no power is supplied to the job separator when start key is pressed. 727 After cluster-A signal turned ON, BUSY-signal stayed [L] more than 7 seconds. (Power to job separator was turned OFF while the tape is being ejected.)