Ricoh MPW7140

• Code: SC919
• Description: External controller down GW The EAC received an interrupt signal from the FLUTE serial driver during print jobs in progress and the connection between the copier and external controller was broken. Note: The EAC is the External API Converter.
• Causes: 1. Turn the machine off. 2. Check the I/F cable to determine if it became disconnected during operation. 3. Turn the machine on.
• Remedy:

• Code: SC920
• Description: Printer error 1 GW An internal application error was detected and operation cannot continue.
• Causes: • Software defective; turn the machine off/on, or change the controller firmware • Insufficient memory
• Remedy:

• Code: SC921
• Description: Printer error 2 GW When the application started, the necessary font was not on the SD card.
• Causes: • Font not on the SD card
• Remedy:

• Code: SC954
• Description: Printer Image Setting Error The IPU did not issue the signal required to start image processing for the printing mode within 60 s after the paper stops for registration.
• Causes: • Software defective • Replace the software (all firmware modules). • IPU defective
• Remedy:

• Code: SC965
• Description: Print start signal error 1 The printer received another print start signal after print job has already started.
• Causes: • Main machine firmware defective • Replace all firmware modules on the main machine
• Remedy:

• Code: SC967
• Description: Print start signal error 2 The printer received another print start signal after print job has already started.
• Causes: • Main machine firmware defective • Replace all firmware modules on the main machine • IOB defective
• Remedy: