PrintCopy.info service

OKI C710n

Error Codes List page 9

  • Code: 231
  • Display: Service call 231: error
  • Description: RFID reader I/F error
    Interface error with the RFID reader is detected.
    01: Communication error between the RFID reader and the engine circuit boards.
    02: Error in the wireless circuit of the RFID reader
    03: Communication error between the RFID reader and the toner cartridge.
    04: Error is detected in the RFID toner cartridge. (In more than 4)
  • Remedy: 01: Same as the error no. 230 02: Replace the RFID R/W board. 03: Check for normal connection of the antenna cable. 04: Check if quantity of the toner cartridge is correct or not.
  • Code: 901 ... 904
  • Display: Re-start the printer. 901: error~ 904: error Note)
  • Description: Abnormal temperature of belt
    901: Shortcircuit
    902: Open circuit
    903: High temperature
    904: Low temperature
  • Remedy: Is the cable from belt thermistor to the high voltage board connected normally? Does this error recur?
    Re-connect the cables normally. Turn on the power again. Replace the belt thermistsor.
  • Code: 918
  • Display: Re-start the printer. 918: error
  • Description: Duplex FAN Alarm Caution
  • Remedy: Fan error inside the duplex unit. Does the error recur when the power is turned off once and back on? Does the error recur when the power is turned off once and back on?
    Check if the Duplex unit is installed normally or not. Check if the fans are installed normally or not. Replace the fan.
  • Code: 923
  • Display: Re-start the printer. 923: error
  • Description: Black image drum lock error
  • Remedy: The K ID does not rotate normally. Does the error display recur when the power is turned off once and back on?
    Check if the K ID is installed normally or not. Replace the K ID unit. Replace the K ID motor.
  • Code: 928
  • Display: Service call 928: error
  • Description: Fuser motor lock error
  • Remedy: Fuser does not rotate normally. Does this error recur?
    Check if the fuser is installed normally or not. Replace the fuser. Replace the fuser motor.
  • Code: 980
  • Display: Service call 980: error
  • Description: Media wrapped around the fuser error
  • Remedy: Media has wrapped around the fuser. Turn off the power. Replace the fuser.
Error Code
Service Mode, Troubleshooting
Parts Catalog
Compatibility
Downloads Files
Home
New Register Forgot Password?
Send message to us