PrintCopy.info service

Riso CR1610

Error Codes List page 1

  • Code: C21
  • Description: Master Loading Error (onto the Drum)
  • Causes: • If the Master sensor does not detect the master (light not reflected) during the master loading when the Drum is at 79В° from the position-A.
  • Remedy: Master Making Unit Set SW OFF &ON.
  • Code: C22
  • Description: Master Misfeed
  • Causes: • If the Master positioning sensor does not detect the master (light not reflected) within 944 pulses after the Write pulse motor activates. • If the light path of the Master tension plate sensor is blocked (Master tension plate is down) when the master feeding has started.
  • Remedy: Master Making Unit Set SW OFF &ON.
  • Code: C23
  • Description: Master Cut Malfunction
  • Causes: • If the Master positioning sensor is still detecting the master (light reflected back) when the Drum is at position-A after the cutting operation and the Master tentioning plate sensor is ON. • If the Master sensor detects the master on the Drum again just after 'C23' error is cleared, 'C23' will be displayed again. Note: 'C23' will be displayed without pressing '* ' key.
  • Remedy: Drum Set Sensor OFF & 5 seconds later ON while Master Positioning Sensor is OFF.
  • Code: C25
  • Description: Master Removal Error
  • Causes: • If the Master removal sensor does not detect the removed master (light path opened) when the Drum rotates to either 70В° or 90В° from the position-A during the master removal, when a master was detected on the Drum.
  • Remedy: Drum Set Sensor OFF & 5 seconds later ON.
  • Code: C26
  • Description: Removed Master Jammed at the Master removal area
  • Causes: • If the Master removal sensor is detecting the removed master (light path blocked) even though the Drum has returned to the position-A after the master removal process.
  • Remedy: Unblock the light path of the Master removal sensor. • Remove the jammed master.
  • Code: C27
  • Description: No Master on the Drum
  • Causes: • If the Master sensor does not find master on the Drum when the Drum is at 79В° during the printing movement.
  • Remedy: Press ALL RESET button.
Error Code
Service Mode, Troubleshooting
Parts Catalog
Compatibility
Downloads Files
Home
New Register Forgot Password?
Send message to us