Sharp AR7024

[Bill]

Perform the following procedure to enter the simulation mode.

When the CLEAR ALL key is pressed, the simulation mode is cancelled.
When the INTERRUPT key is pressed, the process is interrupted and the screen returns to the sub code entering display.
* After canceling the simulation mode, be sure to turn OFF/ON the power and check the operation.
NOTE: If the machine is stopped by a misfeed or paper empty while in
the simulation mode or adjustment, the simulation / adjustment
must be restarted.

[Bill]

Necessary work for maintenance
A. Counter reset
When the drum cartridge, the transfer unit, or the fusing unit is replaced with a new one, the initial detection function operates after turning ON the power to reset each counter automatically.
When the machine is initialized during warming up, or when the simulation is executed or the machine is turned OFF and the door is opened before the machine enters the print (copy) ready state, the initial detection function may not operate normally. Therefore, never execute the simulation or never operate the machine such as turning OFF
the machine power and opening the door before the machine enters the print (copy) ready state after replacing one of the above parts and turning ON the power.
When the counter is not automatically reset, it must be reset manually.
Since the maintenance counter is not automatically reset, they must be cleared by executing SIM20-01.

B. Toner density initial setting
When the developer cartridge is replaced, the initial setting of the toner density needs to be executed by SIM25-2.

C. Other
Perform the following items.
• P-ROM version display (SIM22-14) (Execute according to the necessity.)
• JAM counter reset (SIM24-01)
• Trouble memory reset (SIM24-02)