Epson XP600

Alvin
Posts: 41
Joined: Mon Feb 01, 2021 12:31 pm

Epson XP600

Postby Alvin » Tue Sep 14, 2021 2:55 pm

My Epson XP600 is not functioning properly after I have change the board and it is displaying code 23 which I don't understand.
User avatar
John
Posts: 30
Joined: Sat Oct 21, 2017 9:41 pm

Re: Epson XP600

Postby John » Thu Sep 16, 2021 9:30 am

Epson XP600, XP601, XP605, XP700, XP701, XP702, XP750, XP800, XP801, XP802, XP850
Firmware Update
  • The start-up method of the firmware update mode differs depending on the panel type mounted on the printer, so refer to the appropriate start-up method.
  • If any error occurs during a firmware update and all LEDs light, disconnect the power cable and update it again.
Case of XP-850/XP-800/XP-750/XP-700 series (Touch panel mounted model):
  1. From a power-off status, push "Power on button" while pushing "Down arrow button". (It takes approx. 8 seconds to light the home button.) Power on button, Home button, Down arrow button
    <Panel condition when PC starts normally>
    The following message is displayed on the LCD and all LEDs light: EPSON PRINTER ROM Program Update Mode3
  2. Start the exclusive firmware update program and select the latest firmware data to rewrite it.
  3. After the firmware update is completed and the following message is displayed and also all LEDs light, push the center of the LCD to turn off the printer.
    Program Update Mode
    FINISHED
    ROM1 FIXSUM xxxx
    ROM1 VERSION xxxxx
    ROM2 FIXSUM xxxxx
    ROM2 VERSION
Case of XP-600 series (Electrostatic pad mounted model)
  1. Once turn on/off the printer.
  2. Within a minute after turning off it, push "Power on button" while pushing "Home button", "Left arrow button" and "Stop button". (Until a message is displayed on the LCD)
    Power on button, Home button, Left arrow button, Stop button
    <Panel condition when PC starts normally>
    The following message is displayed on the LCD and all LEDs light.
    EPSON PRINTER ROM
    Program Update Mode
  3. Start the exclusive firmware update program and select the latest firmware data to rewrite it.
  4. After the firmware update is completed and the following message is displayed and also all LEDs light, push "OK button" to turn off the printer.
    Program Update Mode
    FINISHED
    ROM1 FIXSUM xxxx
    ROM1 VERSION xxxxx
    ROM2 FIXSUM xxxx
    ROM2 VERSION xx.xx.xxxx
  • For the models with the touch panel, during in the firmware update mode, the IPL update mode starts if you press and hold "Down arrow button" and "Power on button" together for more than 16 seconds, so the firmware update cannot be started. Therefore, unplug the AC Cable once to turn off the printer, then start the firmware update mode once again.
    EPSON PRINTER ROM
    Program Update Mode
    IPLx
  • For the models with the Electrostatic pad, a firmware update mode cannot be started
    even though you start the printer properly if a minute has passed after turning off the
    printer. So make sure to start the printer within a minute after turning it off.

Return to “Epson XP”

Who is online

Users browsing this forum: No registered users and 1 guest