Toshiba e-Studio 655
Troubleshooting. Image. 05 Blurred image, Poor fusing
5. Blurred image
Defective area | Step | Check items | Prescription |
---|---|---|---|
Paper | 1 | Is the paper in the drawer or LCF damp? | Change paper. Avoid storing paper in damp place. |
Bedewed scanner | 2 | Is the scanner bedewed? | Clean the scanner. |
Drum | 3 | Is the drum surface wet or dirty? | Wipe the drum with a piece of dry cloth. * Do not use alcohol or other organic solvents. |
6. Poor fusing
Defective area | Step | Check items | Prescription |
---|---|---|---|
IH electric power | 1 | Check if the connector contacts properly. | Correct it. |
2 | Is the IH coil shorted or broken? Is there any abnormality on the Heater Control PC board. | Replace the IH Coil or Heater Control PC board. | |
Pressure between fuser roller and pressure roller | 3 | Are the pressure springs working properly? | Check and adjust the pressure springs. |
Fuser roller temperature | 4 | Is the temperature of the fuser roller normal? | Check the setting and correct it. 08-410, 411 |
Developer material/Toner | 5 | Using the specified developer material and toner? | Use the specified developer material and toner. |
Thermistor | 6 | Is there any problem with the thermistor? | Clean or replace the thermistor.. |
Paper | 7 | Is the paper in the drawer or LCF damp? | Avoid storing paper in damp place. |
8 | Is the paper type corresponding to its mode? | Use the proper type of paper or select the proper mode. | |
9 | Is the setting temperature of the fuser roller in each paper type normal? | Check the setting and correct it. 08-410, 412, 413, 437, 1804 | |
10 | Using the recommended paper? | Use the recommended paper. |