Toshiba e-Studio 230L
Adjustment. Auto-Toner Sensor
When the developer material is replaced, adjust the auto-toner sensor in the following procedure.
Procedure (Adjustment Mode (05-200))
- Install the process unit into the equipment.
Note: Do not install the toner cartridge. - While pressing [0] and [5] simultaneously, turn the power ON. The following message will be displayed.
- Key in code [200] and press the [START] button. The display changes as follows.
Notes:
• A indicates the controlled value of the auto-toner sensor output. Press the Up or Down button to change the value.
• B indicates the output voltage of the auto-toner sensor (2.30 V in the above case). The drum, developer unit, etc. are in operation.
• C indicates the latest adjustment value. - After about two minutes, the value B automatically starts changing.
- After a short time, the value B becomes stable and the display changes as follows.
- Check if the value B is within the range of 235 to 245 (the output voltage range of the auto-toner sensor is 2.35 V to 2.45 V).
- If the value B is not within the range of 235 to 245, press the Up or Down button to adjust the value manually.
Note: The relation between the button and the values A and B is as follows.Button to be pressed Value A Value B Up Increased Increased Down Decreased Decreased - Press the [ENTER] or [INTERRUPT] button. The drum, developer unit, etc. are stopped and the following is displayed.
- Turn the power OFF.
- Install the toner cartridge.