Sim No. |
Function |
24 |
5 |
Clear developer counter |
35 |
Clear used toner cartridge counter |
25 |
1 |
Check the operation of the developing section |
2 |
Set toner density initial level when replacing developer |
4 |
Check toner supply control data |
5 |
Check toner density correction data |
26 |
6 |
Set the destination |
7 |
Set the machine ID |
18 |
Set the toner save mode |
30 |
Set the operation mode corresponding to CE control |
35 |
Set SIM22-4 trouble history when a same trouble occurred repeatedly as one trouble or several time |
38 |
Set print operation when the maintenance life is reached |
41 |
Set auto magnification ratio select function in the center binding mode |
49 |
Set the print speed in postcard mode |
50 |
Set the function |
54 |
LCD duty setting |
65 |
Set finisher alarm mode |
66 |
Set simulation password |
69 |
Set toner near end operating condition |
73 |
Adjust image enlargement and A3 wide copy |
74 |
Set OSA trial mode |
78 |
Set remote operation panel password |
79 |
Set security function |
85 |
Set simulation function |
30 |
1 |
Check the operation of the sensors in other than the paper feed section and the control circuit |
43 |
1 |
Set the fusing temperature in each mode |
2 |
Set the fusing operation and preheat mode |
20 |
Set the fusing temperature in each mode (environment correction under low temperature and low humidity of Sim43-2) |
21 |
Set the fusing temperature in each mode (environment correction under high temperature and high humidity of Sim43- 2) |
24 |
Set the fusing operation |
35 |
Check fusing unit pressure state |
44 |
1 |
Set each correction operation function in the image forming section |
2 |
Set the sensitivity of the image density sensor |
4 |
Used to set the conditions of the high density process control operation. |
6 |
Execute the high density process control forcibly |
9 |
Check the high density process control operation data |
12 |
Check the high density process control and the image density sensor operation data |
14 |
Check the output level of the temperature and humidity sensor |
15 |
Set the OPC drum idle rotation |
17 |
Execute refresh operation of the developer and transfer roller |
21 |
Set the halftone process control target |
22 |
Check the toner patch density level in the halftone process control operation |
24 |
Check the correction target and the correction level in the halftone process control operation |
25 |
Set the calculating conditions of the correction value for the halftone process control |
26 |
Execute the halftone process control forcibly |
27 |
Clear the correction data of the halftone process control |
28 |
Set the process control execution condition |
29 |
Set the operating condition of the halftone process control |
37 |
Set the developer bias correction level in the continuous printing operation |
43 |
Check the identification information of the developing unit |
62 |
Set the process control execution condition |
46 |
2 |
Adjust the copy density in the copy mode |
4 |
Adjust the color scan density in the image send mode |
5 |
Adjust the monochrome scan density in the image send mode |
9 |
Adjust the scan image density (SPF) |
16 |
Adjust the copy gray balance and gamma (for all mode) |
19 |
Set the scanning operating condition of the document density in the auto mode |
23 |
Set the density correction of copy high density area (for high density tone gap) |