Sharp MX4071
Simulation mode. List of Classic mode. Codes 43-21 - 46-21
Sim No. | Function | Installation | Maintenance | Adjustment and Settings |
---|---|---|---|---|
43-21 | Set the environment correction under high temperature and high humidity (H/H) for the fusing temperature setting (SIM43-2) in each paper mode | |||
43-24 | Set fuser operation mode | |||
43-35 | Check fusing nip operation | |||
44-1 | Set each correction operation function in the image forming section | |||
44-2 | Adjust the sensitivity of the image density sensor |
2-2 2-3 |
2 | |
44-4 | Set the condition of the high density process control operation | |||
44-6 | Execute the high density process control forcibly | 1-5 | 2-3 | |
44-9 | Display the result data of the high density process control operation | |||
44-12 | Display the operation data of the high density process control and the image density sensor | |||
44-14 | Display the output level of the temperature and humidity sensor | |||
44-15 | Set the OPC drum idle rotation | |||
44-17 | Set refresh operation for process section | |||
44-21 | Set the halftone process control target | 5 | ||
44-22 | Display the toner patch density level in the halftone process control operation | |||
44-24 | Display the correction target and the correction level in the halftone process control operation | |||
44-25 | Set the calculating conditions of the correction value for the halftone process control | |||
44-26 | Execute the halftone process control compulsory | 1-5 | 2-3 | |
44-27 | Clear the correction data of the halftone process control | |||
44-28 | Set the process control execution conditions | |||
44-29 | Set the operating conditions of the process control during a job | |||
44-31 | Adjust the OPC drum phase (Manual adjustment) | |||
44-37 | Set the development bias correction level in the continuous printing operation | |||
44-43 | Display the identification information of the developing unit | |||
44-62 | Set the process control execution conditions | |||
46-1 | Adjust the copy density in the color copy mode | |||
46-2 | Adjust the copy density in the monochrome copy mode | |||
46-4 | Adjust the density in the color image send mode | |||
46-5 | Adjust the density in the monochrome image send mode | |||
46-8 | Adjust the RGB color balance in image send mode | |||
46-9 | Adjust the scan image density | 3 | ||
46-10 | Adjust the copy color balance and the gamma (for each color copy mode) | |||
46-16 | Adjust the monochrome copy density and the gamma (for each monochrome copy mode) | 1-3 | 5 | |
46-19 | Set the operating conditions for the scanning (exposure) density of monochrome auto copy mode documents | |||
46-21 | Adjust the copy color balance (manual adjustment) | 1-3 | 5 |