Sharp MX3631
Simulation mode. List of Classic mode. Codes 66-12 - 67-54
Sim No. | Function | Easy Mode | ||
---|---|---|---|---|
Installation | Maintenance | Adjustment and Settings | ||
66-12 | Check the transmission of the selected signal at 300bps to the line and the main unit speaker (transmission level: soft SW setting) | |||
66-13 | Set dial number for SIM66-14/15/16 dial test | |||
66-14 | Check the dial pulse (10pps) transmission test and to adjust the make time | |||
66-15 | Check the dial pulse (20pps) transmission test and to adjust the make time | |||
66-16 | Check the DTMF signal transmission test and to adjust the transmission level | |||
66-17 | Check the transmission of the DTMF signal to the line and the main unit speaker (transmission level: max) | |||
66-18 | Check the transmission of the DTMF signal to the line and the main unit speaker (transmission level: soft SW setting) | |||
66-21 | Print system error, protocol monitor | |||
66-22 | Set the handset sound volume (Japan model only) | |||
66-29 | Clear the address book data | |||
66-30 | Display the TEL/LIU status change (display is highlighted by status change) | |||
66-31 | Set the output port for TEL/LIU | |||
66-32 | Check the received data and to display the result | |||
66-33 | Check various signals detection result | |||
66-36 | Check send and receive data of MFP controller interface |
|||
66-39 | Set the destination for FAX | |||
66-42 | Write the program to power control installed in the FAX | |||
66-43 | Write the adjustment value into the power control installed in the FAX | |||
66-61 | Set the FAX related soft SW (151-250) | |||
66-62 | Store the FAX receive data to the USB memory in PDF format | |||
67-17 | Clear printer controller | |||
67-20 | Adjust the gray balance (Auto adjustment) | 1-3 | ||
67-21 | Adjust the gray balance (Manual adjustment) | 1-3 | ||
67-24 | Adjust printer color balance (Auto) | 6 | ||
67-25 | Adjust printer color balance (Manual) | 1-4 | 6 | |
67-26 | Set the target color balance of the printer mode auto color balance adjustment | 6 | ||
67-27 | Set the service target of the printer mode auto color balance adjustment | 6 | ||
67-28 | Set the default of the service target of the printer mode auto color adjustment | 6 | ||
67-31 | Clear the printer calibration value | |||
67-33 | Set the gamma of the printer screen | |||
67-34 | Set the density correction in the printer high density section | |||
67-36 | Set the density in the low density section | |||
67-41 | Set 2 color print | |||
67-42 | Set 2 color print color density | |||
67-43 | Adjust the color balance in the 2 color mode | |||
67-46 | Adjust the image enhancement | |||
67-52 | Set the default of the printer screen gamma | 1-3 | ||
67-54 | Adjust printer color balance | 1-3 |