Sharp MX2650FN
Simulation mode. List of Classic mode. Codes 30-1 - 44-31
Sim No. | Installation | Maintenance | Adjustment and Settings | |
---|---|---|---|---|
30-1 | Used to check the operations of the sensors and the detectors in other than the paper feed section and the control circuit | |||
30-2 | Used to check the operations of the sensors and the detectors in the paper feed section and the control circuit | |||
30-30 | Used to check the operation of the motion sensor |
|||
40-2 | Manual paper feed tray paper width sensor adjustment | 4 | ||
40-7 | Used to set the adjustment value of the manual paper feed tray paper width sensor | |||
41-1 | Used to check the operations of the document size sensor and the control circuit | 3 | ||
41-2 | Used to adjust the document size sensor detection level | 3 | ||
41-3 | Used to check the operations of the document size sensor and the control circuit | |||
43-1 | Used to set the fusing temperature in each mode | |||
43-2 | Used to set the fusing operation and preheating | |||
43-20 | Used to set the environment correction under low temperature and low humidity (L/L) for the fusing temperature setting (Sim43-2) in each paper mode | |||
43-21 | Used to set the environment correction under high temperature and high humidity (H/H) for the fusing temperature setting (Sim43-2) in each paper mode | |||
43-24 | Fuser motion setup | |||
43-35 | Fusing nip operation check | |||
44-1 | Used to set each correction operation function in the image forming section | |||
44-2 | Used to adjust the sensitivity of the image density sensor | 2-2 -3 |
2 | |
44-4 | Used to set the conditions of the high density process control operation | |||
44-6 | Used to execute the high density process control forcibly | 1-5 | 2-3 | |
44-9 | Used to display the result data of the high density process control operation | |||
44-12 | Used to display the operation data of the high density process control and the image density sensor |
|||
44-14 | Used to display the output level of the temperature and humidity sensor | |||
44-15 | Used to set the OPC drum idle rotation | |||
44-17 | Process refresh execution | |||
44-21 | Used to set the halftone process control target | 5 | ||
44-22 | Used to display the toner patch density level in the halftone process control operation | |||
44-24 | Used to display the correction target and the correction level in the halftone process control operation | |||
44-25 | Used to set the calculating conditions of the correction value for the halftone process control | |||
44-26 | Used to execute the halftone process control compulsory | 1-5 | 2-3 | |
44-27 | Used to clear the correction data of the halftone process control | |||
44-28 | Used to set the process control execution conditions | |||
44-29 | Used to set the operating conditions of the process control during a job | |||
44-31 | Used to adjust the OPC drum phase (Manual adjustment) |