Samsung MultiXpress M5360RX
Troubleshooting. Image quality 1
1. Vertical Black Line and Band
• Description : Straight thin black vertical line occurs in the printed image.
Probable Cause | Solution |
---|---|
The paper is not the proper type. | Replace the paper. |
The paper path is contaminated by toner residue, debris etc. | Clean the paper path. |
The imaging unit is defective. | Replace the imaging unit. |
The transfer roller is contaminated or worn out. | Replace the transfer roller. |
The pressure roller or heat roller in fuser unit defective. | 1) Turn the machine off. 2) Remove and replace the fuser unit. 3) Turn the machine on. WARNING Do not touch the fuser unit while it is hot. |
2. Vertical White Line, Band
• Description : White vertical voids occurs in the printed image.
Probable Cause | Solution |
---|---|
The paper is not the proper type. | Replace the paper. |
The paper path is contaminated by toner residue, debris etc. | Clean the paper path. |
The imaging unit is defective. | Replace the imaging unit. |
The transfer roller is contaminated or worn out. | Replace the transfer roller. |
The LSU window is contaminated. | 1) Clean the LSU window. 2) Replace the LSU |
The connection between the LSU and main board is defective. | 1) Disconnect and reconnect the harness. 2) Replace the harness. |
3. Horizontal Black Band
• Description : Dark of blurry horizontal stripes occur in the printing periodically.
Probable Cause | Solution |
---|---|
The paper is dirty or not the proper type. | Replace the paper. |
The paper path is contaminated by toner residue, debris etc. | Clean the paper path. |
The contact terminal of the imaging unit is bad. | 1) Clean the contact terminal of the imaging unit. 2) Replace the imaging unit. |
The surface of transfer roller is contaminated or worn out. | Replace the transfer roller. |
The LSU window is contaminated. | 1) Clean the LSU window. |
The pressure roller or heat roller in fuser unit defective. | 1) Turn the machine off. 2) Remove and replace the fuser unit. 3) Turn the machine on. WARNING Do not touch the fuser unit while it is hot. |
HVPS terminal is contaminated. | Clean the contaminated terminal. |
The output from the HVPS is abnormal. | Replace the HVPS board. |
NOTE Roller period table
Roller | Period | Replacement part |
---|---|---|
OPC drum | 94.4 mm | Imaging Unit |
Charge roller | 50.2 mm | |
Developing roller | 43.6 mm | |
Transfer roller | 58.4 mm | Transfer Roller |
Heat roller | 125.6 mm | Fuser Unit |
Pressure roller | 157 mm |