Ricoh MP5000B
Maintenance. PM Tables. Mainframe 1
Symbol key:
C: Clean, R: Replace, L: Lubricate, I: Inspect
| EM | 160K | 320K | 800K | Note | |
|---|---|---|---|---|---|
| Scanner/Optics | |||||
| Reflector | C | Optics cloth | |||
| 1st Mirror | C | Optics cloth | |||
| 2nd Mirror | C | Optics cloth | |||
| 3rd Mirror | C | Optics cloth | |||
| Scanner Guide Rails | C | Do not use alcohol. | |||
| Exposure Glass | C | C | Cleaner | ||
| Toner Shield Glass | C | C | Dry cloth or cleaner | ||
| APS Sensor | C | Dry cloth | |||
| Exposure Glass (Sheet through) | C | C | Cleaner | ||
| Drum (OPC) Area | |||||
| OPC Drum | I | R | |||
| Charge Roller | R | ||||
| Charge Roller Cleaning Roller | R | ||||
| Drum Cleaning Blade 1 | R | ||||
| Quenching Lamp | C | C | Dry cloth | ||
| Pick-off Pawls | R | ||||
| Spurs | C | C | Dry cloth | ||
| ID Sensor | C | C | Perform SP3-001-2 after blower brush cleaning. | ||
| Cleaning Entrance Seal | C | Blower brush. Replace if required. |
|||
| Side Seal | I | ||||
| Development Unit | |||||
| Development Drive Gears | C | Dry cloth | |||
| Development Filter | R | ||||
| Development filter: front | R | ||||
| Development filter: rear | R | ||||
| Developer | I | R | |||
| Entrance Seal | I | ||||
| Side Seal | I | ||||
| Development Roller | C | Dry cloth | |||
| Paper Feed | |||||
| Registration Roller | I | C | Water | ||
| Idle Roller Dust Blade | I | C | Detach and tap gently on flat surface to empty. Blower brush. | ||
| Registration Roller Dust Blade | I | C | Blower brush. | ||
| Feed Rollers | I | C | Water | ||
| Pick-up Rollers | I | C | Water | ||
| Separation Rollers | I | C | Water | ||
| By-pass Feed Roller | I | C | Water | ||
Due to their durability and extended service life, the feed rollers, separation rollers, and pick-up rollers of the mainframe, optional paper trays, and LCT are not replaced at PM.
*1: Lubricate the by-pass feed clutch gear with Silicone Grease G501 every P.M.