Ricoh MP2500LN

The following codes are used:

• Asterisk (*): The settings are saved in the NVRAM. Most of them return to the default values when you execute SP 5801-2
• The DFU menu is for design or factory use only. You must not change the settings.
• Brackets ([ ]): The brackets enclose the setting rage, default value, and minimum step (with unit) as follows: [Minimum to Maximum / Default / Step].
• SSP: The program is in the SSP Mode only. Consult your supervisor before you use this program.

SP1-XXX (Feed)

1106	Display Fusing
1106 1	Displays the fusing temperature (center)
1106 2	Displays the fusing temperature (end)

 

1107*	Fusing Soft Start
	Adjusts the number of zero-cross cycles of the fusing lamp AC supply needed to bring the fusing lamp power to 100% while bringing the lamp up to the standby temperature or while copying. Increase this value if the machine is experiencing sudden power dropouts (* "Fusing Temperature Control" in the chapter "Detailed Section Descriptions").
1107 1	Warm Up Soft Start	[0 = 10 cycles / 1 = 20 cycles / 2 = 50 cycles]
1107 2	Other Soft Start	[0 = 5 cycles / 1 = 10 cycles / 2 = 20 cycles]

 

1108*	Set-Fusing Start	[0 = 1s / 1 = 1.5s / 2 = 2s]
1108 1	Specifies the interval for fusing-temperature control (* "Fusing Temperature Control" in the chapter "Detailed Section Descriptions").

 

1109	Nip Band Check
1109 1	Checks the fusing nip band (* "NIP Band Width Adjustment" in the "Replacement and Adjustment").

 

1110*	Fan Control Timer
1110 1	[30 to 60 / 30 / 1 s/step] Inputs the fan control time. The fan maintains normal speed for the specified time after occurrence of an SC or following entry into Warm-up mode, Low Power mode, or Night/ Off mode.

 

1159*	Fusing Jam SC Code Setting	[0=No / 1=Yes]
1159 1	This SP mode detects SC559. Set this SP mode to 'Yes' if the machine experiences paper jam problems on a continual basis.

 

1902	Display-AC Freq.
1902 1	Displays the fusing lamp power control frequency (as detected by the zero cross signal generator). The displayed value is 1/5 the actual frequency: 10 = 50 Hz, 12 = 60 Hz.

 

1903*	Feed Clutch Boost
	Adjusts the amount of extra push that the feed clutch gives to the been corrected at registration. This feature helps the registration	paper after the skew has roller feed certain types
	of paper (such as thick paper). Increase the value if thick paper is jamming after feeding from the registration roller.
1903 1	By-pass tray	[0 to 10 / 6 / 1 mm/step]
1903 2	2nd, 3rd, 4th tray	[0 to 10 / 3 / 1 mm/step]

 

1908*	Optional Tray Adj.
	Adjusts the reverse time for the upper and lower paper lift motors.
1908 1	1st optional	[-2 to 2 / 0 / 1/step]
1908 2	2nd optional

 

1911*	By-pass Envelope
1911 1	[0 = No / 1= Yes] The program dedicated to envelope printing runs when you enable this program (SP 1911-1) and you select "Thick Paper" as the paper type of the by-pass tray (System Settings > Tray Paper Settings > Paper Type: Bypass Tray).