Ricoh IMC6000
Troubleshooting. WHEN FLUORESCENT/ LED LAMPS FLICKER
Symptom
Under the usage environment of this machine, at the placement location, fluorescent and/or LED lamps flicker.
Cause
The procedure varies by the flicker occurrence timing. So check the occurrence timing, and do the procedure that matches the timing.
Timing | Solutions | Side effect |
---|---|---|
Recovery from energy saving | Set SP1-135-001 (Inrush Control) to "1 (ON)". | Recovery time from energy saving becomes slower approx. 0.4 sec.. |
After the recovery from energy saving | Set SP1-135-001 (Inrush Control) to "1 (ON)". Set SP1-135-002 (Flicker Control) to "1 (ON)". |
• Recovery time from energy saving becomes slower approx. 0.4 sec.. • In the case of the adhesion amount of an image is large, an offset may occur. • In the case of a fusing offset occurs, in the related SP to fusing offsets, setting valuesmust be changed |
If it has not been improved in the above, do the following procedures in addition; • Stop the lighting of the fusing lamp after the warmup. Set SP1-121-001(Switch:Rotation Start/Stop:Time:After Reload) to"0 sec". |
The fusing temperature drops during the operation. After copying starts, the fusing temperature is raised up to a printable temperature. Because of that, copying completion time becomes slower (approx. 1-2 sec.). | |
Printing | Set SP1-135-002 (Flicker Control) to "1 (ON)". | • In the case of the adhesion amount of an image is large, an offset may occur. • In the case of a fusing offset occurs, in the related SP to fusing offsets, setting values must be changed. |
Related SP to Fusing Offsets
SP Name | SP No. | Value |
---|---|---|
Print Target Temp.:Plain1:FC:Center |
SP1-105-001 | As initial values + 10 degrees are the upper limits, change values to improve offsets. |
Print Target Temp.:Plain1:BW:Center |
SP1-105-003 | |
Print Target Temp.:Plain2:FC:Center |
SP1-105-005 | |
Print Target Temp.:Plain2:BW:Center |
SP1-105-007 | |
Print Target Temp.: Thin:FC:Center |
SP1-105-009 | |
Print Target Temp.: Thin:BW:Center |
SP1-105-011 | |
Print Target Temp.: M-thick:FC:Center |
SP1-105-013 | |
Print Target Temp.: M-thick:BW:Center |
SP1-105-015 |