Ricoh D0B2 G1027
Adjustment after Replacement. Printing
• Make sure the paper is loaded properly in each paper tray before starting these adjustments.
• Print the registration page (Test Pattern Printing) to use for these adjustments.
Registration - Leading Edge/Side-to-Side
A: Leading edge registration (3 ± 2 mm)
B: Side-to-side registration (2 ± 1.5 mm)
1. Check the leading edge registration [A] for each paper feed station, and adjust them using SP1- 001
Tray | SP No. | Threshold |
---|---|---|
Tray: Plain | SP1-001-002 | 4.2 ± 1.5 mm |
Tray: Mid Thick | SP1-001-003 | |
Tray: Thick | SP1-001-004 | |
Bypass: Plain | SP1-001-007 | |
Bypass: Mid Thick | SP1-001-008 | |
Bypass: Thick | SP1-001-009 | |
Duplex: Plain | SP1-001-013 | |
Duplex: Mid Thick | SP1-001-014 | |
Duplex: Thick | SP1-001-015 |
2. Check the side-to-side registration [B] for each paper feed station, and adjust them using SP1-002.
Tray | SP No. | Threshold |
---|---|---|
Bypass | SP1-002-001 | 2 ±1.5 mm |
Tray Main1 | SP1-002-002 | |
Tray Bank1 | SP1-002-004 | |
Tray Bank2 | SP1-002-005 | |
Duplex | SP1-002-006 |
Main Scan Magnification
• Use an S5S test chart to perform the following adjustments.
1. Check the magnification, and if necessary, adjust it using SP2-102-001 (Main Scn Mag. Adj.). The specification is ± 0.5%.