Ricoh B209 Aficio 3030 R-C4

Switching Between SP Mode and Copy Mode for Test Printing

1. In the SP mode, select the test print and then press Copy Window.
2. Use the copy window (copier mode), to select the appropriate settings (paper size, etc.) for the test print.
3. Press [Start] to execute the test print.
4. Press SP Mode (highlighted) to return to the SP mode screen and repeat from step 1.

Selecting the Program Number

Program numbers have two or three levels.

1. Before you begin, refer to the Service Tables to find the SP that you want to adjust.
2. Press the Group number on the left side SP Mode window that contains the SP that you want to adjust.
3. Use the scrolling buttons in the center of the SP mode window to display the SP number that you want to open, and then press that number to expand the list.
4. Use the center touch-panel buttons to scroll to the number and title of the item that you want to set and press. The small entry box on the right is activated and displays the default or the current setting below.

NOTE:
Refer to the Service Tables for the range of allowed settings.

1. To enter a setting
   • Press [Stop/Clear] to toggle between plus and minus and then use the keypad to enter the appropriate number. The number you enter writes over the previous setting.
   • Press [#] to enter the setting. (If you enter a number that is out of range, the key press is ignored.)
   • When you are prompted to complete the selection, press Yes.
2. If you need to perform a test print, press Copy Window to open the copy window and select the settings for the test print. Press [Start] twice, and then press SP Mode (highlighted) in the copy window to return to the SP mode display.
3. When you are finished, press Exit twice to return to the copy window.