OKI MC573dn
Self-diagnostic mode. Factory-Shipping mode switching
The Factory-Shipping mode switching is used for switching from the Factory to Shipping mode.
- Enter the self-diagnostic mode(Level1) and, until the following message appears, press the [2] or [8] button.
FACTORY MODE SET - Press the [6] button. The following message appears. Press the [2] or [8] button until the option to set (refer to the table shown below) appears
FACTORY MODE
SHIPPING MODE * - A setting for the option can be selected by pressing the [6] button with the option on the display.
- Press the [6] button with the setting on the display. The setting is stored in the EEPROM. The state in step 2 is restored.
- Repeat steps 2 through 4 when necessary.
- Press the [4] button to end the option (the state in step 1 is restored).
Option | Settings | Function |
---|---|---|
FACTORY MODE | FACTORY MODE | Establishes the Factory mode (a fuse-cut disabling mode). |
SHIPPING MODE | Deselects the Factory mode to enable the fusecut function. | |
FUSE INTACT Note: ****** is either INTACT or BLOWN. |
BELT UNIT XXXXXX | Displays the fuse status of the transfer belt unit. |
FUSE UNIT XXXXXX | Displays the fuse status of the fuser. |