OKI ES8434
Troubleshooting. Paper jam (Error 381) 3
Jam occurs at the way of paper path.
Motor driving check
Check item | Check work | Actions to be taken at NG |
---|---|---|
Paper hopping motor driver, belt motor driver and ID motor | Confirm that the paper hopping motor, belt motor and ID motor work normally by using the [Motor & Clutch Test] of the self-diagnostic mode. Check if any load exists or not. | Replace the CU/PU board, or replace the defective motor among paper hopping motor, belt motor and ID motor, or replace the ID unit or belt unit. |
Paper hopping motor, belt motor | Remove the MOTERCL connector 1 of the CU/ PU board (ME2 PCB) and check the following at the connector side. Several MΩ between pin-1 – FG Several MΩ between pin-2 – FG Several MΩ between pin-3 – FG Several MΩ between pin-4 – FG Several MΩ between pin-5 – FG Several MΩ between pin-6 – FG Several MΩ between pin-7 – FG Several MΩ between pin-8 – FG |
Replace the CU/ PU board (ME2 PCB). |
Installed condition of fuser unit.
Check item | Check work | Actions to be taken at NG |
---|---|---|
Fuser unit | Check if the fuser nit is pressed in until the connector in the bottom of the fuser unit is completely connected. | Re-set the fuser unit. |