|
|
|
|
|
Does a jam error occur when turning on the power? |
|
Yes Is there any paper in the entrance sensor? |
|
|
Yes Remove the paper |
|
No Does the entrance sensor lever work normally? (It moves freely by touching.) |
|
|
No Replace the entrance sensor lever. |
|
Yes Clean the entrance sensor, or replace the main board. |
No A jam error occurs after feeding paper. |
|
Yes Is the paper sent to the entrance sensor lever? |
|
|
Yes Does the entrance sensor lever work normally? (It moves freely by touching.) |
|
|
|
No Replace the entrance sensor lever. |
|
|
Yes Is the IN_WR connector of the main board connected properly? |
|
|
|
No Connect the IN_WR connector properly. |
|
|
Yes Clean the entrance sensor, or replace the main board. |
|
No Replace the paper feed roller, pick-up roller or paper cassette. |
No Does the paper feed roller rotate? |
|
Yes Set the paper cassette appropriately. |
No Does the paper feed clutch work normally? |
|
Yes Replace the paper feed roller and shaft. |
No Is HCLT connector of the main board appropriately connected? |
|
No Connect HCLT connector appropriately. |
Yes Is the coil resistance of the paper feed clutch (Normal resistance: Pin1, Pin2, and approx. 192Ω) normally? |
|
No Replace the paper feed clutch. |
Yes Replace the main board. |