Lexmark MS911

PRINTER SENSOR TESTS

These tests verify that the printer sensors are working properly.

1. Enter the Diagnostics Menu, and then navigate to: SENSOR TESTS > PRINTER TESTS
2. Select a sensor.
3. Manually toggle the sensor.
   Note: The sensor status on the screen toggles between Open and Close when the sensor is working properly.

2 x 500.Sheet Tray Sensor Tests

These tests verify that the 2 x 500-sheet tray sensors are working properly.

1. Enter the Diagnostics Menu, and then navigate to: SENSOR TESTS > 2 x 500‑Sheet Tray Sensor Test
2. Select a sensor.
3. Manually toggle the sensor.
   Note: The sensor status on the screen toggles between Open and Close when the sensor is working properly.

2500.Sheet Tray Sensor Tests

These tests verify that the 2500-sheet tray sensors are working properly.

1. Remove the tray inserts from tray 1 and tray 2.
2. Enter the Diagnostics Menu, and then navigate to: SENSOR TESTS > 2500.Sheet Tray Sensor Tests
3. Select a sensor.
4. Manually toggle the sensor.
   Note: The sensor status on the screen toggles between Open and Close when the sensor is working properly.

3000.Sheet Tray Sensor Tests

These tests verify that the 3000-sheet tray sensors are working properly.

1. Remove the tray inserts from tray 1 and tray 2.
2. Enter the Diagnostics Menu, and then navigate to: SENSOR TESTS > 3000.Sheet Tray Sensor Tests
3. Select a sensor.
4. Manually toggle the sensor.
   Note: The sensor status on the screen toggles between Open and Close when the sensor is working properly.

Staple and Hole Punch Finisher Sensor Tests

These tests verify that the staple and hole punch finisher sensors are working properly.

1. Remove the tray inserts from tray 1 and tray 2.
2. Enter the Diagnostics Menu, and then navigate to: SENSOR TESTS > Staple and Hole Punch Finisher Sensor Test
3. Select a sensor.
4. Manually toggle the sensor.
   Note: The sensor status on the screen toggles between Open and Close when the sensor is working properly.

Hole Punch Booklet Finisher Sensor Tests

These tests verify that the hole punch booklet finisher sensors are working properly.

1. Remove the tray inserts from tray 1 and tray 2.
2. Enter the Diagnostics Menu, and then navigate to: SENSOR TESTS > Hole Punch Booklet Finisher Sensor Tests
3. Select a sensor.
4. Manually toggle the sensor.
   Note: The sensor status on the screen toggles between Open and Close when the sensor is working properly.

Staple Finisher Sensor Tests

These tests verify that the staple finisher sensors are working properly.

1. Remove the tray inserts from tray 1 and tray 2.
2. Enter the Diagnostics Menu, and then navigate to: SENSOR TESTS > Staple Finisher Sensor Tests
3. Select a sensor.
4. Manually toggle the sensor.
   Note: The sensor status on the screen toggles between Open and Close when the sensor is working properly.