Lexmark 3400-481 MB2236adw

Entering the Config menu

The Config menu consists of menus, settings, and operations that are used to configure the printer.

To access the Config menu, press and hold Right arrow and OK on the control panel, and then turn on the printer.

Config Menu

Menu item	Description
USB Configuration USB PnP 1* 2	Change the USB driver mode of the printer to improve its compatibility with a personal computer.
USB Configuration	Set whether the USB device driver enumerates as a USB
USB Scan to Local	Simple device (single interface) or as a USB Composite device
On*	(multiple interfaces).
Off
USB Configuration	Set the USB port to run at full speed and disable its high-speed
USB Speed	capabilities.
Full
Auto*
Tray Configuration	Show message about the tray status.
Show Tray Insert Message
Off
Only for unknown sizes*
Always
Tray Configuration	Specify the page orientation when loading A5 paper size.
A5 Loading
Short Edge*
Long Edge
Tray Configuration Paper Prompts Auto* Manual Paper Envelope Prompts Auto* Manual Envelope	Set the paper source that the user fills when a prompt to load paper or envelope appears.
Tray Configuration Action for Prompts Prompt user* Continue Use current	Set the printer to resolve paper- or envelope-related change prompts.
Reports Menu Settings Page Event Log Event Log Summary	Print reports about printer menu settings, status, and event logs.
Supply Usage And Counters Clear Supply Usage History Reset Black Cartridge Counter Reset Black Imaging Unit Counter	Reset the supply page counter or view the total printed pages.
Fax Configuration Fax Low Power Support Disable Sleep Permit Sleep Auto*	Specify the printer power setting when it is in fax mode.
Print Configuration Font Sharpening 0-150(24*)	Set a text point-size value below which the high-frequency screens are used when printing font data.
Print Configuration Print Density 1-5 (3*) Copy Density 1-5 (3*)	Adjust the toner density when printing or copying documents.
Device Operations Quiet Mode On Off*	Set the printer to reduce the amount of noise that it makes when printing. Note: This setting slows down the overall performance of the printer.
Device Operations Panel Menus Enable* Disable	Set the printer to show the control panel menus.
Device Operations Clear Custom Status	Erase all custom messages.
Scanner Configuration Scanner Manual Registration Print Quick Test	Print a Quick Test target page. Note: Make sure that the margin spacing on the target page is uniform all the way around the target. If it is not, then the printer margins may need to be reset.
Scanner Configuration Scanner Manual Registration Front ADF Registration Flatbed Registration	Manually register the flatbed and ADF after replacing the ADF, scanner glass, or controller board.
Scanner Configuration Edge Erase ADF Edge Erase 0-6 (3*) Flatbed Edge Erase 0-6 (3*)	Set the size, in millimeters, of the no-print area around an ADF or flatbed scan job.
Scanner Configuration Disable Scanner Enabled* Disabled ADF Disabled	Disable the scanner if it is not working properly.
Scanner Configuration Tiff Byte Order CPU Endianness* Little Endian Big Endian	Set the byte order of a TIFF-formatted scan output.
Scanner Configuration Exact Tiff Rows Per Strip On* Off	Set the RowsPerStrip tag value of a TIFF-formatted scan output.
Note: An asterisk (*) next to a value indicates the factory default setting.