Kyocera TASKalfa 8353ci
Maintenance Mode. Modes List: U000 - U070
| Section | Maintenance item | Outline |
|---|---|---|
| General | U000 Printing Maintenance Report | Printing each report and exporting them to a USB drive |
| U001 Exit the maintenance mode | Exit from the maintenance mode | |
| U002 Set Factory Default | Initializing to the factory-default setting | |
| U003 Setting the telephone number of the service person | Set the telephone number of the service person | |
| U004 Machine Number | Display the machine serial number settings | |
| U010 Setting the maintenance mode ID | Set the maintenance mode ID | |
| U018 Firmware self verification | Check the Firmware falsification | |
| U019 Firmware Version | Display the Firmware version of the PWB | |
| Initializing | U021 Initializes Memory | Initializing the backup RAM |
| U023 Reset Settings | Store and recover the adjustment related data stored in the scanner engine PWB | |
| U024 Formatting HDD | Format/configure the HDD | |
| U025 Firmware update (S) | Update the Firmware | |
| U026 Retrieve the backup data | Retrieve the backup data | |
| Drive Paper feed Conveying Cooling |
U030 Motor operation check | Drive the drive motor |
| U031 Check the conveying switch | Check the conveying switch On/Off | |
| U032 Clutch operation check | Check the paper conveying clutch operation | |
| U033 Solenoid operation check | Drive the paper conveying and toner supply solenoids | |
| U034 Paper timing data adjustment | Adjust the leading edge timing and the center line | |
| U035 Folio size setting | Set the Folio paper length and width. | |
| U037 Fan operation check | Drive each fan motor | |
| U051 Registration paper loop amount adjustment | Adjusts the paper loop amount between the rollers | |
| U052 Fuser motor speed adjustment | Input the sensor data value and correct the fuser motor speed | |
| U053 Adjusting the motor speed | Set each motor speed | |
| U059 Fan mode setting | Set the drive mode f the conveying fan motor | |
| Optical | U061 Lamp lighting check | Turn the exposure lamp on |
| U063 Shading position adjustment | Change the shading position of the scanner | |
| U065 Adjusting the magnification for table scanning | Adjust the magnification for table scanning | |
| U066 Adjusting the table scanning timing | Adjust the leading edge timing for table scanning | |
| UJ067Adjusting the table scanning center | Adjust the center line for table scanning | |
| U068 DP Scanning position adjustment | Adjust the starting position for DP scanning | |
| U070 DP magnification adjustment | Adjust the magnification of DP scanning |