Kyocera TASKalfa 306ci
Firmware. 2 Procedures
Preparations
Unzip the file containing the downloaded firmware and then copy the firmware and high-speed master file (skip files: ES_SKIP.ON) in the root folder of the USB memory.
*: If the high-speed master file exists, the same version firmware update is skipped.
Procedures
- After turning the power switch on and the screen is properly displayed, turn the power switch off.
- Insert the USB memory with the firmware into the USB memory slot.
- Turn the power switch on.
- [FW-UPDATE] and the progress indicator is displayed.
*: Several kinds of firmware updates are processed simultaneously. - "Completed" is displayed when the firmware update is completed.
- Check if the new firmware versions are displayed.
*: When there is no corresponding master file, "No Change" is displayed.
* is displayed after the firmware version update that has been skipped.
*: ----------is displayed when the FAX PWB, the option equipment, etc. is not installed. - Unplug the power cord and disconnect the USB memory.
- Plug in the power cord and turn the power switch (a) on.
- Check that the "Home" screen is displayed and then turn the power switch (a) off.
For the case of an error
When an error occurs during the firmware upgrade, the process is immediately interrupted and the error code and error message are indicated.
Error code | Error content |
---|---|
0000 | Other |
0100 | No Master file |
0200 | Version mismatch of the master file |
03xx | No Download File (No.xx) |
04xx | File (No.xx) Checksum mismatch |
05xx | File (No.xx) Preparation failure |
06xx | File (No.xx) Oversize |
08xx | File (No.xx) Writing failure |
S000 | Other signature verification error *1 |
S001 | Signature verification file is inadequate |
N001 | Network connection failed. *2 (There is no upgrade target interrupted) |
N002 | Network connection failed. *3 (There is an upgrade target interrupted) |
*1: Including the expired FM certificate
*2: Automatically restarted for the normal start-up since the normal start-up is available next time.
*3: Transferred to the USB upgrade mode instead of the automatic restart since the normal start-up may not be available next time.
Indication of the signature verification result
Official signature verification file | Indicate the result |
---|---|
Both certificate and signature files exist and verification is successful. | Version number |
Both certificate and signature files exist but verification is unsuccessful. | S000 |
Neither certificate nor signature files exist. Or either of them does not exist. | S001 |
- Unplug the power cord and disconnect the USB memory.
- Plug in the power cord and turn the power switch (a) on.
- Check that the "Home" screen is displayed and then turn the power switch (a) off.
Important
Never turn the power switch (a) off or disconnect the USB drive (b) during the firmware update.
Safe-Update
When the firmware update was interrupted by power shut-off or disconnecting the USB memory during the firmware update, the firmware update is retried at the next power-on.
Turn the main power on again while the USB memory is installed.
* The firmware update that was already completed before power shut-down is skipped.