Kyocera TASKalfa 255c
Troubleshooting. Jam Codes: 6023 - 7953
*: Refer to figure for paper jam location
| Code | Contents | Conditions | Jam location* |
|---|---|---|---|
| 6023 | Staple cover open | The staple cover is opened during operation. | G |
| 6043 | DF top cover open | The DF top cover is opened during operation. | G |
| 6103 | DF paper conveying sensor non arrival jam | The paper conveying sensor (PCS) does not turned on even if a specified time has elapsed after the machine eject signal was received. | I |
| 6113 | DF paper conveying sensor stay jam | The paper conveying sensor (PCS) does not turn off within the specified time of its turning on. | G |
| 6123 | DF paper conveying sensor remaining jam | The paper conveying sensor (PCS) does not turned on when the power is turned on or the cover is closed. | G |
| 6413 | DF eject paper sensor stay jam | The eject paper sensor (EPS) does not turn off within the specified time. | G |
| 6423 | DF eject paper sensor remaining jam | The eject paper sensor (EPS) does not turned on when the power is turned on or the cover is closed. | G |
| 6803 | Front adjustment plate oper- ation ON error | The adjustment sensor 1 (ADS1) does turned on when the job is executed. | H |
| 6813 | Front adjustment plate oper- ation OFF error | The adjustment sensor 1 (ADS1) does not turned off when the job is executed. | H |
| 6903 | Rear adjustment plate oper- ation ON error | The adjustment sensor 2 (ADS2) does not turned on when the job is executed. | H |
| 6913 | Rear adjustment plate oper- ation OFF error | The adjustment sensor 2 (ADS2) does not turned off when the job is executed. | H |
| 7013 | Staple operation error | The next staple hasn't head-poked for the next copy to bind after a predetermined interval while clinching has commenced. | H |
| 7023 | Staple initial operation error | Head-poking has not been accomplished after 10 attempts in the initialization at power up or closing the cover. | H |
| 7913 | Sequence error 1 (operation prohibited) | Operation commenced in the state the finisher is prohibited to operate. | G |
| 7923 | Sequence error 2 (initialoperation error) | A request for maintenance mode has occurred in the state the finisher is prohibited to operate or has commenced operation. | G |
| 7933 | Sequence error 3 (Error in the reception of backup data) |
A backup data command has been received in the state the operation has initiated. | G |
| 7943 | Sequence error 4 (standby) | Operation has started in the state standby is pro- hibited. | G |
| 7953 | Sequence error 5 (Error in between copies) |
An illegal inter-page or inter-copy interval has occurred. | G |