Kyocera TASKalfa 2550ci
Troubleshooting. Mechanical problems 2
If the part causing the problem was not supplied, use the unit including the part for replacement.
Problem | Causes/check procedures | Corrective measures |
---|---|---|
(7) Abnormal noise is heard. |
Check if the rollers, pulleys and gears operate smoothly. | Grease the bushes and gears. |
Check if the following clutches are installed correctly. Paper feed clutch Mid clutch Registration clutch Duplex clutch |
Check visually and remedy if necessary. | |
(8) No primary original feed. |
Check if the surfaces of the following pul- leys are dirty with paper powder. DP forwarding pulley DP paper feed roller |
Clean with isopropyl alcohol. |
Check if the following pulleys is deformed. DP forwarding pulley DP paper feed roller |
Check visually and replace any deformed (see page 1-5-29). | |
(9) Multiple sheets of orig- inal are fed. |
Original is not correctly set. | Set the original correctly. |
Check if the DP separation pulley is worn. | Replace the DP separation pulley if it is worn (see page 1-5-29). | |
(10) Originals jam. |
Originals being used do not conform with the specifications. | Use only originals conforming to the specifications. |
Check if the surfaces of the following pul- leys are dirty with paper powder. DP forwarding pulley DP paper feed roller |
Clean with isopropyl alcohol. | |
Check if the contact between the regis- tration roller and registration pulley is cor- rect. | Check visually and remedy if necessary. | |
Check if the contact between the convey- ing roller and conveying pulley is correct. | Check visually and remedy if necessary. | |
Check if the contact between the eject roller and eject pulley is correct. | Check visually and remedy if necessary. | |
Check if the contact between the switch- back roller and switchback pulley is cor- rect. | Check visually and remedy if necessary. |