Kyocera ECOSYS P6230cdn
Troubleshooting. Abnormal Noise 4
10. Abnormal sound from inside the machine
Open and close operation failure of the toner supply opening of the toner container, the lack of toner amount, or the toner condensation
Step | Check description | Assumed cause | Measures |
---|---|---|---|
1 | Checking the toner supply opening | The spring for opening and closing of the toner supply opening is hooked with the other parts, or deformed. | Open and close the toner supply opening of the toner container to correct |
2 | Checking the toner remaining amount | The agitating paddle is bent or toner amount is small in the toner container | Check the toner remaining amount and replace the toner container if necessary. |
3 | Checking the toner container | The torque increases due to the toner condensation. | Shake the toner container enough and reinstall it. Or, replace it. |
11. Abnormal sound from inside the machine
Smudges / foreign objects adhesion or the toner condensation in the developer section
Step | Check description | Assumed cause | Measures |
---|---|---|---|
1 | Checking the toner supply opening | The spring to open/close the toner shutter is caught up or deformed. | Open and close the toner supply opening of the developer unit to correct |
2 | Checking the developer roller | The original roller shat and bushing are dirty or foreign objects adhere | Check if the developer roller rotates. If not rotating smoothly, clean the shaft or the bushing of the developer roller. |
3 | Checking the developer unit | The torque inside the developer unit increased due to the toner condensation, etc. | Clean the developer unit. Then, replace it if the issue is not resolved. |
12. Abnormal sound from inside the machine
Frictional wear, smudges / foreign objects adhesion, or the waste toner clogging in the drum section
Step | Check description | Assumed cause | Measures |
---|---|---|---|
1 | Executing Drum refresh | Toner is not enough on the drum. | Execute the drum refresh to supply the toner to the cleaning unit. |
2 | Checking the drum screw | The drum screw does not properly rotate. | Check if the drum screw rotates. If not rotating smoothly, clean it. If it locks up, replace the drum unit. |
3 | Cleaning and applying the grease | Foreign objects are on the tooth of the drum drive gear, or the grease is not enough. | Clean the tooth of the drum drive gear and apply the grease to them. |
4 | Checking the drum unit and the developer unit | The torque inside the drum unit increased due to the waste toner clogging, etc. | Execute the drum refresh. If not repaired, replace the drum unit. |