Kyocera ECOSYS P6230cdn

4. Abnormal sound from the exit section

Smudges / foreign objects adhesion in the exit section

Step	Check description	Assumed cause	Measures
1	Cleaning and applying the grease	The bearings or gears are dirty or the foreign objects adhere.	Clean the bushing and the gear of the exit roller and apply grease to them.
2	Cleaning and applying the grease	The bearings are dirty or the foreign objects adhere.	Clean the shaft of the exit pulley and apply grease to it.
3	Checking the shaft of the feed-shift guide	The bearings are dirty or the foreign objects adhere.	Clean the shaft of the feedshift guide and apply grease to it.

5. Abnormal sound from the primary paper feed section

Frictional wear, smudges / foreign objects adhesion, attachment failure of the primary paper feed section

Step	Check description	Assumed cause	Measures
1	Checking the gear and the clutch	The parts such as the gear or the clutch are not properly attached.	Reattach the primary paper feed drive components such as the gear or the clutch if they are not properly attached.
2	Cleaning and applying the grease	The gear, bushing, etc. is dirty or foreign objects adhere to it	Clean the primary paper feed drive components such as the gear or the bushing and apply the grease to them.
3	Cleaning and applying the grease	The shaft, bushing, etc. is dirty or foreign objects adhere to it	Clean the shaft and the bushing of the paper feed roller and apply the grease to them.
4	Checking the separation pad	The separation pad surface is dirty or worn down.	Clean the separation pad, or replace it if necessary.

6. Abnormal sound from the machine front side

Wear, dirtiness, foreign objects adhesion or attachment failure at the MP feed section

Step	Check description	Assumed cause	Measures
1	Checking the gear and the clutch	The parts such as the gear or the clutch are not properly attached.	When the gears or the clutch in the MP paper feed drive section are not properly attached, reattach them.
2	Cleaning and applying the grease	The shaft or the bushing is dirty or foreign objects are on them.	Clean the shaft and the bushing of the MP paper feed roller and apply the grease to them.
3	Checking the MP separation pad	The surface of the MP separation pad is dirty or worn down.	Clean the MP separation pad. Then, replace it if necessary.
4	Checking the MP conveying belt	The MP conveying belt is not attached properly or is loosened	Reattach the MP conveying belt. Then, replace it if not repaired.
5	Reattach the MP lift plate.	The MP lift plate is not attached properly.	Reattach the MP lift plate.