Kyocera ECOSYS M2530dn
Maintenance Mode. Modes List: U000 - U612
Section | Item No. | Content of maintenance item | Initial setting |
---|---|---|---|
General | U000 | Outputting an maintenance report | |
U002 | Setting the factory default data | ||
U004 | Setting the machine number | ||
Operation panel and support equipment | U203 | Checking DP operation | |
U222 | Setting the IC card type | Other | |
U250 | Setting the maintenance cycle | 100000 | |
U251 | Checking/clearing the maintenance count | ||
U252 | Setting the destination | ||
U253 | Switching between double and single counts | Double count | |
U260 | Selecting the timing for copy counting | EJECT | |
U285 | Setting service status page | ON | |
U332 | Setting the size conversion factor | 1.0 | |
U345 | Setting the value for maintenance due indication | 0 | |
Image processing | U411 | Auto Adj Scn | |
U425 | Set Target | ||
Fax | U600 | Initializing all data | |
U601 | Initializing permanent data | ||
U603 | Setting user data 1 | DTMF | |
U604 | Setting user data 2 | 2 (120 V) 1 (220-240 V) |
|
U605 | Clearing data | ||
U610 | Setting system 1 | ||
Setting the number of lines to be ignored when receiving a fax at 100% magnification | 3 | ||
Setting the number of lines to be ignored when receiving a fax in the auto reduction mode | 0 | ||
Setting the number of lines to be ignored when receiving a fax (A4R/LetterR) in the auto reduction mode | 0 | ||
U611 | Setting system 2 | ||
Setting the number of adjustment lines for automatic reduction | 7 | ||
Setting the number of adjustment lines for automatic reduction when A4 paper is set | 22 | ||
Setting the number of adjustment lines for automatic reduction when letter size paper is set | 26 | ||
U612 | Setting system 3 | ||
Selecting if auto reduction in the auxiliary direction is to be performed | ON | ||
Setting the automatic printing of the protocol list | OFF |