Konica-Minolta bizhub 958

3.1 Replace feed roller, pick-up roller, separation roller (tray 1, tray 2)

Procedure	Replacement part/Service job	Adjustment/setting items
1	Replace feed roller, pick-up roller, separation roller (tray 1, tray 2)	[Service Mode] / [Counter] / [Life] / [Counter Clear]

3.2 Replace feed roller, separation roller assy (manual bypass tray)

Procedure	Replacement part/Service job	Adjustment/setting items
1	Replace feed roller, separation roller assy	[Service Mode] / [Counter] / [Life] / [Counter Clear]

3.3 Install LCT (Built-in)

Procedure	Replacement part/Service job	Adjustment/setting items
1	Install LCT (Built-in)	[Service Mode] / [System2] / [LCT (Built-in) Size Settings]
2		[Service Mode] / [Machine] / [Printer Area] / [Printer Image Centering Side 1]
3		[Service Mode] / [Machine] / [Printer Area] / [Prt. Image Center. Side 2 (Dup)]

3.4 Replace CCD unit

Procedure	Replacement part/Service job	Adjustment/setting items
1	Replace CCD unit	[Service Mode] / [System2] / [CCD Calibration]
2		[Service Mode] / [Machine] / [Scan Area] / [Scanner Image Side Edge]

3.5 Replace developing unit

Procedure	Replacement part/Service job	Adjustment/setting items
1	Replace developing unit	[Service Mode] / [Imaging Process Adjustment] / [Gradation Adjust]

3.6 Replace drum unit

Procedure	Replacement part/Service job	Adjustment/setting items
1	Replace drum unit	[Service Mode] / [Imaging Process Adjustment] / [Gradation Adjust]

3.7 Replace fusing unit

Procedure	Replacement part/Service job	Adjustment/setting items
1	Replace fusing unit	[Service Mode] / [Counter] / [Life] / [New Release]

3.8 Replace PH unit

Procedure	Replacement part/Service job	Adjustment/setting items
1	Replace PH unit	[Service Mode] / [Machine] / [Printer Area] / [Leading Edge Adjustment]
2		[Service Mode] / [Machine] / [Printer Area] / [Printer Image Centering Side 1]

3.9 Replace original size detection sensor

Procedure	Replacement part/Service job	Adjustment/setting items
1	Replace original size detection sensor	Installation of original size sensor
2		[Service Mode] / [State Confirmation] / [Sensor Check]

3.10 Replace scanner home sensor

Procedure	Replacement part/Service job	Adjustment/setting items
1	Replace scanner home sensor	[Service Mode] / [Machine] / [Scan Area] / [Image Position: Leading Edge]

3.11 Replace MFP board

Procedure	Replacement part/Service job	Adjustment/setting items
1	Replace MFP board	Entering the machine type information
2		Installing the firmware
3		Restore (backup) data
4		[Service Mode] / [Imaging Process Adjustment] / [Gradation Adjust]