Konica-Minolta bizhub 601
Service Mode. 01. How to Enter
This machine is provided with a service mode for various types of adjustments/settings. Data adjusted and/or set in this mode are stored in the NVRAM board (NRB).
Start and exit of the service mode
A. Starting and exiting service mode while the power is ON
- Check to see if the regular copy screen is displayed.
- Press the Utility/Counter key.
- "Meter Count/ Utility screen"
Press [Meter Count]→[Check Details]. - "Meter Count screen"
Press the Stop key and key pad in the order shown below.
Stop→0→0→Stop→0→1
Note
• When the CE password is set, a password is required to input to enter the service mode. - "Service Mode screen"
The service mode is in the start-up condition. - Select an item to set.
The setup screen of each item is displayed. - Conduct required operations, and press [END/OK] after completion of the operations.
The setting made at step 6 becomes effective. - "Service Mode screen"
Press [Exit] to return to the regular copy screen.
B. Starting and exiting service mode while the power is OFF
- While pressing the Utility/Counter key, turn ON the power switch (SW2).
- Trouble reset screen appears.
- Press the [Trouble reset].
NOTE
• If a particular malfunction code does not occur, it is not necessary to press the [Trouble reset]. • If a particular malfunction code occurs, See "Trouble reset". - On the Operation panel, press the following keys.
Stop→0→0→Stop→0→1 - Service Mode screen appears.
Note
• When the CE password has been set, you must enter the password to enter the service mode. - Press the key for an item you want to configure.
The setting screen for each item appears. - Conduct necessary operations and turn OFF the SW2 after completion of operations.
- The new settings become effective after restart.