Konica-Minolta bizhub 501
Troubleshooting. Jam code list 3
Classification | Jam code | Cause | Resulting operation | Correction | ||
---|---|---|---|---|---|---|
FS | J-2006 | During operation | While in the print, the front door opens |
The main body and the optional e stop | Remove jammed paper if any from optional device / main body. | |
FS-522 | J-2007 | While in the print, the guide plate switch (SW4) turns OFF. | ||||
FS-523 | While in the up drive operation of the tray, the shutter switch (SW2) turns ON. | |||||
J-2008 | While in the print, FS-523 comes off from the main body. | |||||
RU | J-2009 | While in the print, the front door opens. | ||||
FS-523 | J-2010 | While in the print, the upper door opens. | ||||
MT | While in the print, the right door opens. | |||||
SD | While in the print, the saddle-stitching section opens. | |||||
Conveyance | J-3000 | The registration sensor (PS1) does not turn OFF within a specified period of time after the registration clutch (CL1) turns ON. | The printer sec- tion stops immediately. | Open ADU and remove jammed paper if any. | ||
J-3100 | The fusing exit sensor (PS3) does not turn ON within a specified period of time after the registration clutch (CL1) turns ON. | |||||
Fusing | J-3200 | The fusing exit sensor (PS3) does not turn OFF within a specified period of time after the PS3 turns ON. | ||||
Reversing | J-3300 | The reverse sensor (PS27) does not turn ON within a specified period of time after the fusing exit sensor (PS3) turns ON. | ||||
J-3400 | The reverse sensor (PS27) does not turn OFF within a specified period of time after the PS27 turns ON. | |||||
Other | J-5001 | A print start signal is not sent out from the overall control board (OACB) within a specified period of time after the registration sensor (PS1) turns ON. | The main body and the optional device stop immediately. | Open the right door of PC, the vertical convey- ance door of the main body and ADU and remove jammed paper if any. |