Konica-Minolta bizhub 211
Service Mode. MAINTENANCE COUNT
MAINTENANCE COUNT
Functions
- To enter an appropriate counter value (0 to 999999) as the tentative maintenance time.
- Specify the setting on maintenance counter to “1” or “2”: If the maintenance life is reached, the maintenance call (M1) or service call [Call Service (M1)] will appear.
NOTE
▪ The counter value is decremented until it reaches -999999 even after it has counted 0.
Setting/ Procedure
- The default setting is 0.
“0” : Not counted
1 : Counted (The maintenance call display is given when the counter reaches 0.)
2 : Counted (The service call display is given and the initiation of any new copy cycle is inhibited when the counter reaches 0.) - When “1” or “2” is selected, a screen will then appear to allow the counter value to be entered.
IU LIFE STOP MODE
Functions
- When the supplies life count. reaches the life value, the IU life will be detected.
- The mode when the IU life is reached, is specified by this setting.
CONTINUOUS :
Enables copying. Maintenance call display is given.
STOP :
Disables copying. service. call display is given and the initiation of any new copy cycle is inhibited.
NOTE
▪ The counter value is decremented until it reaches -999999 even after it has counted 0. In this case, however, no image quality is guaranteed.
Setting/ Procedure
• The default setting is CONTINUOUS.