Canon imageRUNNER Advance 4051
Troubleshooting. Jam Code. Buffer Pass Unit-H1, Finisher-D1, Puncher-A1
Buffer Pass Unit-H1
| ACC ID | Jam Code | Type | Sensor ID | Sensor Name/Description |
|---|---|---|---|---|
| 00 | 0111 | DELAY | PS1 | Paper in sensor |
| 00 | 0112 | DELAY | PS2 | Paper out sensor |
| 00 | 0211 | STNRY | PS1 | Paper in sensor |
| 00 | 0212 | STNRY | PS2 | Paper out sensor |
| 00 | 0A11 | POWER ON | PS1 | Paper in sensor |
| 00 | 0A12 | POWER ON | PS2 | Paper out sensor |
| 00 | FF11 | SEQ NG*1 | PS1 | Paper in sensor |
| 00 | FF12 | SEQ NG*1 | PS2 | Paper out sensor |
*1: The state is recovered by opening and closing the Door, or turning OFF and then ON the power supply. If it is not recovered by the above operation, it is considered an error near the target sensor. Disconnect and then connect the connectors around the target sensor, check if the cable is open circuit, and replace the sensor.
Inner Finisher-D1 + Inner Hole Puncher-A1
| ACC ID | Jam Code | Type | Sensor ID | Sensor Name/Description |
|---|---|---|---|---|
| 02 | 1001 | DELAY | S1 | Entrance sensor |
| 02 | 1002 | DELAY | SR3 | Punch path sensor |
| 02 | 1101 | STNRY | S1 | Entrance sensor |
| 02 | 1102 | STNRY | SR3 | Punch path sensor |
| 02 | 1300 | POWER ON | S1/S6 | Entrance sensor/Processing tray sensor |
| 02 | 1400 | DOOR OP | SW1 | Front cover switch |
| 02 | 1500 | OTHER | S18/S19 | Stapler HP sensor/Stapler edging sensor |
| 02 | 1701 | INIT ROT | S1/SR3 | Entrance sensor/Punch path sensor |
| 02 | 1644 | OTH JAM | SR5 | Punch HP sensor |
| 02 | 1646 | OTH JAM | SR1 | Punch solenoid sensor |
| 02 | 1C20 | POWER ON | S2 | Shift roller HP sensor |
| 02 | 1C32 | POWER ON | S10 | Stapler move HP sensor |
| 02 | 1C40 | POWER ON | S14 | Stack tray clock sensor |
| 02 | 1C42 | POWER ON | S23 | Additional tray clock sensor |
| 02 | 1C67 | POWER ON | S3 | Shift roller release sensor |
| 02 | 1C6F | POWER ON | S5 | Entrance roller release /stopper HP sensor |
| 02 | 1C71 | POWER ON | S13 | Gripper arm sensor |
| 02 | 1C75 | POWER ON | S7 | Gripper unit HP sensor |
| 02 | 1F00 | OTH JAM | S1 | Entrance sensor |