Canon imageRUNNER 1430J
Service Mode. ADJ-XY 2
ADJ-Y-DF2
Adjustment of image position in ADF mode: horizontal scan [back side]
| Details | - Adjust the image reading start position in the horizontal scanning direction for ADF reading. - The rear image position is moved 0.1mm to rear side by setting value 1. |
| Use case | When replacing the Main Controller PCB / clearing RAM data. |
| Adj/set/operate method | Enter the setting value (switch negative/positive by * key) and then press OK key. |
| Caution | After the setting value is changed, write the changed value on the service label. |
| Display/adj/set range | -16 to 16 |
| Unit | 0.1mm |
| Default value | 0 |
ADJ-X-MG
Fine Adjustment of image magnification ratio in book mode: vertical scan
| Details | - Fine-adjust image magnification ratio in vertical scanning direction for copyboard reading by changing speed of the reader motor. - The image magnification ratio is increased/decreases 0.1% by setting value 1. +: Reduction -: Enlargement |
| Use case | When replacing the Main Controller PCB / clearing RAM data. |
| Adj/set/operate method | Enter the setting value (switch negative/positive by * key) and then press OK key. |
| Caution | The Fine-adjustment over the image magnification standard in vertical direction may occur image error. |
| Display/adj/set range | -100 to 100 |
| Unit | 0.01% |
| Default value | 0 |
STRD-POS
Adjustment of reading position for ADF reading: vertical scan
| Details | Adjust reading position in vertical scanning for ADF reading |
| Use case | When replacing the Main Controller PCB / clearing RAM data. |
| Adj/set/operate method | Enter the setting value (switch negative/positive by * key) and then press OK key. |
| Caution | After the setting value is changed, write the changed value on the service label. |
| Display/adj/set range | -20 to 20 |
| Unit | 0.1mm |
| Default value | 0 |
| Related service mode | COPIER > FUNCTION > INSTALL > STRD-POS |