Canon iR1133
Service Mode. ADJ-XY 2
ADJ-Y-DF
Adj img pstn in ADF mode:horz scan
| Details | To adjust the image reading start position in the horizontal scanning direction at ADF reading. When replacing the Main Controller PCB/clearing the RAM data, enter the value of service label. As the value is incremented by 1, the image position moves to the trailing edge side by 0.1 mm. |
| Use case | • When replacing the Reader Unit • When replacing the CIS Unit • When replacing the Main Controller PCB |
| Adj/set/operate method | Enter the setting value (switch negative/positive by -/+ key) and press OK key. |
| Caution | After the setting value is changed, write the changed value in the service label. |
| Display/adj/set range | -10 to 10 |
| Unit | 0.1 mm |
| Default value | 0 |
ADJ-X-MG
Fine adjustment of image magnification ratio (vertical scanning direction)
| Details | To make a fine adjustment of image magnification ratio in the vertical scanning direction by changing the reading cycle of CIS. When replacing the Main Controller PCB/clearing the RAM data, enter the value of service label. As the value is incremented by 1, the image magnification changes by 0.01%. +: Reduce -: Enlarge |
| Use case | • When replacing the Reader Unit • When replacing the CIS Unit • When replacing the Main Controller PCB |
| Adj/set/operate method | Enter the setting value (switch negative/positive by -/+ key) and press OK key. |
| Caution | After the setting value is changed, write the changed value in the service label. |
| Display/adj/set range | -200 to 200 |
| Unit | 0.01 % |
| Default value | 0 |
STRD-POS
Adjustment of reading position at ADF stream reading
| Details | To adjust the reading position at ADF stream reading. When replacing the Main Controller PCB/clearing the RAM data, enter the value of service label. |
| Use case | When replacing the Main Controller PCB/clearing RAM data |
| Adj/set/operate method | Enter the setting value (switch negative/positive by -/+ key) and press OK key. |
| Caution | After the setting value is changed, write the changed value in the service label. |
| Display/adj/set range | -20 to 20 |
| Unit | 0.1 mm |
| Default value | 0 |
| Related service mode | COPIER> FUNCTION> INSTALL> STRD-POS |