Canon iR Advance 6265i
Troubleshooting. Alarm Code 4
| Alarm Code | Title | A. movement /B. cause /C. measures |
|---|---|---|
| 04-0075 | Error in Reverse Detachment Solenoid connection | Movement: Jam occurred at the time of large size paper reverse delivery. Cause: Connection of the Reverse Detachment Solenoid (SL12) cannot be detected. Measures:
|
| 06-0003 | Web absence notice | Movement: The Web Drive Solenoid is turned ON 4 times after the Fixing Cleaning Web Level Sensor performs detection. Cause: Remaining level of the Fixing Cleaning Web is low. Measures: Replace the Fixing Cleaning Web. |
| 09-0006 | 2D Shading ROM error 1 | Movement: Turn OFF the 2D Shading. Cause: After clearing the drum, not reading the EEPROM. Measures: Execute COPIER>FUNCTION>2D-SHADE>2D- READ. |
| 09-0007 | 2D Shading ROM error 2 | Movement: Turn OFF the 2D Shading. Cause: After reading ROM data, calculated checksum value and checksum of ROM does not match. Measures: Install the correct ROM. |
| 09-0008 | Drum HP signal noise alarm | Movement: Only when the 2D shading is ON, the accuracy of shading is degraded and an image error occurs. Uneven density may occur. Cause: The Drum HP cycle is shorter than the specified cycle. Measures:
|
| Alarm Code |
Title | A. movement /B. cause /C. measures |
| 09-0009 | Drum HP signal absence alarm | Movement: Only when the 2D shading is ON, the accuracy of shading is degraded and an image error occurs. Uneven density may occur. Cause: The Drum HP cycle is longer than the specified cycle. Measures:
|
| 10-0001 | No toner (Bk) (RDS creates) | - |
| 11-0002 | Waste Toner Container full (Photosensitive Drum) |
Movement: A message "The waste toner container is full." is displayed on the Control Panel, and the machine is stopped. Cause: The Waste Toner Counter reaches 600000. Measures: Clean the Waste Toner Container. Reset the Waste Toner Counter. |
| 30-0004 | Pre-transfer Charging PCB Harness disconnection (connection error) | Movement: Pre-transfer charging high voltage is not output. An image error like discharge trace occurs. Cause: Connection error of the Pre-transfer Charging PCB (PCB26). Measures:
|
| 31-0005 | Environment Sensor reading alarm | Movement: It becomes as follow: environment temperature= 0 degC, environment humidity= 0%. Cause: Connection of the Environment Sensor cannot be detected. Measures:
|